Search PubMed⌕ Search

Biomedical subjects

Ian Barnes

Publications and source records attributed to Ian Barnes.

23 records · Page 2Linked to original sources

Characterization of genetic miscoding lesions caused by postmortem damage.

The spectrum of postmortem damage in mitochondrial DNA was analyzed in a large data set of cloned sequences from ancient human specimens. The most common forms of damage observed are two complementary groups of transitions, termed "type 1" (adenine-->guanine/thymine-->cytosine) and "type 2" (cytosine-->thymine/guanine-->adenine). Single-primer extension PCR and enzymatic digestion with uracil-N-glycosylase confirm that each of these groups of transitions result from a single event, the deamination of adenine to hypoxanthine, and cytosine to uracil, respectively. The predominant form of transition-manifested damage varies by sample, though a marked bias toward type 2 is observed with increasing amounts of damage. The two transition types can be used to identify the original strand, light (L) or heavy (H), on which the initial damage event occurred, and this can increase the number of detected jumping-PCR artifacts by up to 80%. No bias toward H-strand-specific damage events is noted within the hypervariable 1 region of human mitochondria, suggesting the rapid postmortem degradation of the secondary displacement (D-loop) H strand. The data also indicate that, as damage increases within a sample, fewer H strands retain the ability to act as templates for enzymatic amplification. Last, a significant correlation between archaeological site and sample-specific level of DNA damage was detected.

Archaeology↗

Distribution patterns of postmortem damage in human mitochondrial DNA.

The distribution of postmortem damage in mitochondrial DNA retrieved from 37 ancient human DNA samples was analyzed by cloning and was compared with a selection of published animal data. A relative rate of damage (rho(v)) was calculated for nucleotide positions within the human hypervariable region 1 (HVR1) and cytochrome oxidase subunit III genes. A comparison of damaged sites within and between the regions reveals that damage hotspots exist and that, in the HVR1, these correlate with sites known to have high in vivo mutation rates. Conversely, HVR1 subregions with known structural function, such as MT5, have lower in vivo mutation rates and lower postmortem-damage rates. The postmortem data also identify a possible functional subregion of the HVR1, termed "low-diversity 1," through the lack of sequence damage. The amount of postmortem damage observed in mitochondrial coding regions was significantly lower than in the HVR1, and, although hotspots were noted, these did not correlate with codon position. Finally, a simple method for the identification of incorrect archaeological haplogroup designations is introduced, on the basis of the observed spectrum of postmortem damage.

Animals↗

Formation of methane sulfinic acid in the gas-phase OH-radical initiated oxidation of dimethyl sulfoxide.

Dimethyl sulfoxide (CH3S(O)CH3: DMSO) is an important product of dimethyl sulfide (CH3SCH3: DMS) photooxidation. The mechanism of the OH-radical initiated oxidation of DMSO is still highly uncertain and a major aim of recent studies has been to establish if methane sulfinic acid (CH3S(O)OH: MSIA) is a major reaction product In the present work the products of the OH-radical gas-phase oxidation of dimethyl sulfoxide have been investigated in the absence and presence of NOx All experiments were performed in a 1,080 L reaction chamber in 1,000 mbar synthetic air at 284 +/- 2 K using long-path FT-IR spectroscopy and ion chromatography to monitor and quantify reactants and reaction products. Formation of methane sulfinic acid in high yield (80-99%) was observed in both in the absence and presence of NOx, and the results support that it is the major primary reaction product Other products observed included dimethyl sulfone (CH3S(O)2CH3: DMSO2), sulfur dioxide (SO2), methane sulfonic acid (CH3S(O)2OH: MSA), and methane sulfonyl peroxynitrate (CH3S(O)2OONO2: MSPN). The formation behavior of these products is in line with their source being mainly secondary production via oxidation of a primary product, i.e. MSIA.

Dimethyl Sulfoxide↗

FTIR kinetic, product, and modeling study of the OH-initiated oxidation of 1-butanol in air.

A kinetic and product study was performed on the reaction of OH radicals with 1-butanol in a 480 L indoor photoreactor and also in the EUPHORE outdoor smog chamber in Valencia, Spain. Long path in situ FTIR spectroscopy and gas chromatography with photoionization detection were used to analyze reactants and products. Using a kinetic relative rate technique, a rate coefficient of k(OH + 1-butanol) = (8.28 +/- 0.85) x 10(-12) cm3 s(-1) was measured in 740 Torr synthetic air at 298 +/- 2 K. The reaction products observed and their fractional molar yields were (in percent) butanal (51.8 +/- 7.1), propanal (23.4 +/- 3.5), ethanal (12.7 +/- 2.2), and formaldehyde (43.4 +/- 2.4). In addition, the results support the probable formation of 4-hydroxy-2-butanone. Propanal, ethanal, and formaldehyde could also be formed in secondary reactions of some of the primary aldehydic products. However, under the conditions employed in the experiments, the contribution from secondary reactions is very minor. On the basis of the product studies, a detailed atmospheric degradation mechanism was constructed and tested against experimental data by chemical box model calculations. Measured and simulated concentration-time profiles for selected reactants were in excellent agreement.

1-Butanol↗