Biomedical subjects

I Shiozawa

Publications and source records attributed to I Shiozawa.

21 records · Page 2Linked to original sources

PubMedDate not supplied

A study of the bond strength and color of ultralow-fusing porcelain.

PURPOSE: The purpose of this study was to investigate the effects of different bonding agents, surface roughness, and acid pickling on the bond strength and color of ultralow-fusing porcelain fused to gold alloy. MATERIALS AND METHODS: Porcelain-metal specimens were made to 25 mm x 3 mm x 0.5 mm with a 1-mm porcelain thickness. A 3-point bending test was used to evaluate the bond strength. The color of the porcelain was measured using a dental chromameter, and the data were processed in the CIE Lab system. The color difference (delta E*) was calculated for the tested groups. RESULTS: Good bond strength and color could be achieved regardless of the use and type of bonding agent. Surface roughness and acid pickling had more effect on the bond strength than on color. CONCLUSION: The type of the bonding agent, surface roughness, and acid pickling influenced the bond strength but had minimal effects on the color of ultralow-fusing porcelain. This ultralow-fusing porcelain could produce a color closer to the Vita shade than the conventional low-fusing porcelain.

Acid Etching, Dental↗

PubMedDate not supplied

Fatigue behavior of the zinc-phosphate cement layer.

PURPOSE: Fatigue behavior of luting cement film between model fixed partial dentures (FPD) and their dies was investigated to gain a better understanding of the mechanical properties of zinc-phosphate cement. MATERIALS AND METHODS: Fifty-six brass dies were made, half of them with grooves and half without grooves. A cantilever FPD for each die was cast in Au-Pd-Ag alloy. Four linear strain gauges were attached to the marginal portions of each retainer. The FPDs were cemented to the dies using zinc-phosphate cement. A fatigue test machine was used to cyclically load the specimens with 50 or 100 N for 5.5 x 10(5) cycles (1 Hz) in 37 degrees C water. During the fatigue test, strain measurements were made after every 0.5 x 10(5) load cycles to discover if strain response was altered. After completion of the fatigue test, ultimate tensile strength of each specimen was measured and statistically analyzed by 2-way analysis of variance. RESULTS: With or without grooves, strain responses were the same at every periodic strain measurement throughout the 50-N fatigue test. For the 100-N fatigue test, strain responses for the specimens without grooves were different before and after cyclic testing, but there was no difference for the specimens with grooves. There were no significant differences in tensile strength among the specimens after the fatigue tests. CONCLUSION: No fatigue fracture was observed in zinc-phosphate cement film after repetitive loading. Repetitive loading may improve stress transmission within the zinc-phosphate cement film.

Analysis of Variance↗

PubMedDate not supplied

Surface strain on crown and luting cement fractures.

This study investigated fractures of the cement layer between a crown and a die. Model crowns were luted on dies with zinc phosphate cement and various magnitudes of load were applied. Surface strain on the crown was measured using strain gauges. Seal was evaluated using dye penetration and tensile tests. Results showed that cement fracture affected surface strain behavior on the crown and was detected using the surface strain measurement. The dye penetration test and the tensile test could not be used to detect the cement fracture. It is suggested that the three-dimensional relative positioning between the crown and the die affected the development of the cement fracture.

Analysis of Variance↗