Implementation of donor screening for infectious agents transmitted by blood by nucleic acid technology: update to 2003.
Explore the source record for details and available documents.
Biomedical subjects
Publications and source records attributed to H T Cuijpers.
Explore the source record for details and available documents.
BACKGROUND AND OBJECTIVES: Since July 1 1999, four laboratories in the Netherlands have been routinely screening plasma minipools for the release of labile blood components utilizing hepatitis C virus nucleic acid amplification technology (HCV NAT). This report describes the performance evaluation of the HCV NAT method and the quality control results obtained during 6 months of routine screening. MATERIALS AND METHODS: Plasma minipools of 48 donations were prepared on a Tecan Genesis robot. HCV RNA was isolated from 2 ml of plasma by using the NucliSens Extractor and amplified and detected with the Cobas HCV Amplicor 2.0 test system. For validation of the test system the laboratories used viral quality control (VQC) reagents of CLB. RESULTS: Initial robustness experiments demonstrated consistent detection of PeliSpy HCV RNA samples of 140 genome equivalents/ml (geq/ml) in each station of the installed Nuclisens Extractors. Further 'stress' tests with a highly viraemic sample of approximately 5 x 10(6) geq/ml did not contaminate negative samples processed on all Extractor stations in subsequent runs. In the validation period prior to July 1999, 1021 pools were tested with the following performance characteristics: 0.1%, initially false reactive; 0.89%, failure of internal control detection; 0.97%, no eluate generated by the Extractor; and 100% reactivity of the PeliSpy 140 geq/ml control in 176 Extractor runs and a 98% reactivity rate of the PeliSpy 38 geq/ml control in 102 test runs. By testing the PeliCheck HCV RNA genotype 1 dilution panels 49 times, an overall 95% detection limit of 30 geq/ml ( approximately 8 IU/ml) and a 50% detection limit of 5 geq/ml was found by the four laboratories. In the first 6 months of routine screening, the minimum requirement for invalid results (2%) was exceeded with some batches of silica and NucliSens Extractor cartridges. From November 1999 to February 2000, the manufacturer (Organon Teknika) improved the protocol for silica absorption of the Nuclisens Extractor -- the cartridge design as well as the software of the Extractor. During the next 6 months of observation in 2000, the percentages of false initial reactives and invalids were 0.05% and 1.4%, respectively, in 8962 pools tested. Of these invalid results, 0.74% and 0.66% were caused by Extractor failure and negative internal control signals, respectively. The PeliSpy HCV RNA 'stop or go' run control of 140 geq/ml was 100% reactive, but invalid in 16/1375 (1.2%) of cases. The PeliSpy run control of 38 geq/ml for monitoring sensitivity of reagent batches was reactive in 95% of 123 samples tested. CONCLUSIONS: Each of the four HCV NAT laboratories in the Netherlands have achieved similar detection limits that are well below the sensitivity requirements of the regulatory bodies. After improvement of the NucliSens Extractor procedure, the robustness of the test system has proved to be acceptable for routine screening and timely release of all labile blood components.
Accurate assessment of plasma HIV RNA levels at low concentrations is clinically important. We evaluated a second-generation quantitative HIV RNA assay (NucliSens HIV-1 QT), and three simple adaptations of the NucliSens standard protocol to lower the lower cutoff level. The assays were evaluated in constructed panels with known HIV RNA concentrations and in clinical samples. Results were compared with those obtained with the first generation (NASBA HIV-1 QT) and with two other commercially available assays: the Amplicor HIV Monitor test and the Quantiplex assay. In a constructed panel, results obtained by NASBA QT were on average 0.13 log(10) copies/ml (SD 0.15) higher than those of NucliSens. The NucliSens assay could quantify HIV RNA in at least 50% of the samples down to 518 (2.71 log(10)) copies/ml and NASBA QT to 5.80 x 10(3) (3.76 log(10)) copies/ml). Both assays correlated well with the known input (R NucliSens = 0.99; R NASBA QT = 0.996), but results were more variable at lower input levels. With the three different ultrasensitive NucliSens adaptations, HIV RNA could be quantified in at least 50% of the samples down to 100 (2.00 log(10)), 46 (1.66 log(10)), and 10 (1.00 log(10)) copies/ml, respectively. In patient samples, Amplicor results were on average 0.11 (SD 0.20) log(10) copies/ml above, NucliSens 0.02 (SD 0.29) copies/ml above, and Quantiplex 0.13 (SD 0.19) copies/ml below the mean of the three assay results per sample. The variation remained the same over the range of RNA levels with all three assays. The NucliSens assay can quantify HIV RNA at lower levels than the NASBA QT and is comparable to other commercially available assays. The lower cutoff of the NucliSens can be lowered down to 10 copies/ml.
Rh (rhesus) D is the dominant antigen of the Rh blood group system. Recent advances in characterization of the nucleotide sequence of the cDNA(s) encoding the Rh D polypeptide allow the determination of the Rh D genotype at the DNA level. This can be of help in cases in which red blood cells are not available for phenotyping, eg, when in concerns a fetus. We have tested three independent DNA typing methods based on the polymerase chain reaction (PCR) for their suitability to determine the Rh D genotype. DNA derived from peripheral blood mononuclear cells from 234 Rh-phenotyped healthy donors (178 Rh D positive and 56 Rh D negative) was used in the PCR. The Rh D genotypes, as determined with a method based on the allele-specific amplification of the 3' noncoding region of the Rh D gene described by Bennett et al (N Engl J Med 329:607, 1993), were not concordant with the serologically established phenotypes in all cases. We have encountered 5 discrepant results, ie, 3 false-positive and 2 false-negative (a father and child). Rh D genotyping with the second method was performed by PCR amplification of exon 7 of the D gene with allele-specific primers. In all donors phenotyped as D positive tested so far (n = 178), the results of molecular genotyping with this method were concordant with the serologic results, whereas a false-positive result was obtained in one of the D-negative donors (also false-positive in the first method). Complete agreement was found between genotypes determined in the third method, based on a 600-bp deletion in intron 4 of the Rh D gene described by Arce et al (Blood 82:651, 1993), and serologically determined phenotypes. The Rh blood group system is complex, and unknown polymorphisms at the DNA level are expected to exist. Therefore, although genotypes determined by the method of Arce et al were in agreement with serotypes, it cannot yet be regarded as the golden standard. More experience with this or other methods is still needed.
It has been shown that the Rhesus (Rh) blood group antigens are encoded by two homologous genes: the Rh D gene and the Rh CcEe gene. The Rh CcEe gene encodes different peptides: the Rh C, c, E, and e polypeptides. Only one nucleotide difference has been found between the alleles encoding the Rh E and the Rh e antigen polypeptides. It is a C-->G transition at nucleotide position 676, which leads to an amino acid substitution from proline to alanine in the Rh e-carrying polypeptide. Here we present an allele-specific primer amplification (ASPA) method to determine the Rh E and Rh e genotypes. In one polymerase chain reaction, the sense primer had a 3'-end nucleotide specific for the cytosine at position 676 of the Rh E allele. In another reaction, a sense primer was used with a 3'-end nucleotide specific for the guanine at position 676 of the Rh e allele and the Rh D gene, whereas the antisense primer had a 3'-end nucleotide specific for the adenine at position 787 of the Rh CcEe gene. We tested DNA samples from 158 normal donors (including non-Caucasian donors and donors with rare Rh phenotypes) in these assays. There was full concordance with the results of serologic Rh E/e phenotyping. Thus, we may conclude that the ASPA approach leads to a simple and reliable method to determine the Rh E/e genotype. This can be useful in Rh E/e genotyping of fetuses and/or in cases in which no red blood cells are available for serotyping. Moreover, our results confirm the proposed association between the cytosine/guanine polymorphism at position 676 and the Rh E/e phenotype.
Explore the source record for details and available documents.
RNA derived from enriched reticulocytes of Rh-phenotyped donors was isolated, reversely transcribed into cDNA and amplified with Rh-specific primers by polymerase chain reaction. Nucleotide sequence analysis of the entire coding region of the Rh cDNAs was carried out. Four types of cDNAs were identified, tentatively designated as RhSCI, RhSCII, RhSCIII and RhSCIV. Comparison of RhSCII with RhSCI (identical to the previously reported RhIXb/30A cDNA), showed single base pair difference. Since RhSCI and RhSCII were found to be related to the presence of E or e antigen, respectively, the P226A amino acid polymorphism appears to be the genetic basis of the E/e polymorphism. RhSCIII was demonstrated to be a transcript derived from the RhD gene, with 35 amino acid substitutions as compared to RhSCI. RhSCIV was found to be present only in RhC-positive individuals, indicating that RhSCIV encodes a polypeptide carrying the C antigen. Six nucleotide changes, resulting in four amino acid substitutions W16C, L60I, N68S and P103S, were observed between RhSCII and RhSCIV, probably representing the C/c polymorphism.
Glanzmann's thrombasthenia (GT) is the result of the absence or of an altered and dysfunctional expression on the platelet membrane of the fibrinogen receptor (glycoprotein [GP] IIb/IIIa complex). Various molecular genetic mechanisms have been found to be responsible for this inherited disease. In a patient with a severe type of GT, we have found a splice variant in the GP IIIa gene that leads to premature chain termination. Immunoprecipitation experiments, using monoclonal antibodies specific for GP IIb/IIIa, showed that GP IIb/IIIa was not detectable on the platelet membrane. Amplification of reversely transcribed platelet GP IIIa mRNA by the polymerase chain reaction and subsequent sequence analysis showed a 86-bp deletion, which corresponds to exon i of the GP IIIa gene. This deletion results in a shift of the reading frame leading to eight altered amino acids followed by a premature termination codon. Analysis of the corresponding genomic DNA fragments showed three mutations in the exon i-intron i boundary region of the GP IIIa gene. One of these mutations is a G-->T transition that eliminates the GT splice donor site in the wild type. This base pair change creates a restriction site for the enzyme Mse I. Allele-specific restriction enzyme analysis (ASRA) with Mse I of amplified genomic DNA of the parents and the proposita showed that both parents (who are first cousins) are heterozygous, whereas the proposita is homozygous for the G-->T substitution.
Explore the source record for details and available documents.