Biomedical subjects

Gerald Farrell

Publications and source records attributed to Gerald Farrell.

4 recordsLinked to original sources

PubMed2006

Low-cost wavelength measurement based on a macrobending single-mode fiber.

A low-cost all-fiber wavelength measurement technique is proposed and demonstrated. A macrobending standard single-mode fiber is developed as an edge filter with an optimal design and simple surface processing. A ratiometric wavelength measurement system employing the developed macrobending fiber filter demonstrates a resolution of approximately 10 pm in a wavelength range from 1,500 to 1,560 nm with ease of assembly and calibration.

Journal Article↗

PubMed2006

All-fiber multimode-interference-based refractometer sensor: proposal and design.

A novel all-fiber refractometer sensor is proposed, which is based on multimode interference in the multimode fiber core section sandwiched between two single-mode fibers. A wide-angle beam propagation method in the cylindrical coordinate is employed as the modeling tool for simulation and design of the proposed refractometer sensor. The design for a refractometer is presented that shows that the refractometer would have an estimated resolution of 5.4 x 10(-5) for refractive indices from 1.33 to 1.45 and of 3.3 x 10(-5) for refractive indices from 1.38 to 1.45 through the choice of an appropriate length of the multimode fiber core section.

Journal Article↗

PubMed2006

Modeling liquid-crystal devices with the three-dimensional full-vector beam propagation method.

Simulation of light propagation within nematic liquid-crystal (LC) devices is considered, of which the director is aligned normal to the z axis. A three-dimensional full-vector finite-difference beam propagation method for an anisotropic medium is presented and an alternating direction implicit scheme is adopted. Simulations of light propagation in a bulk polarization converter, a waveguide with a LC covering layer, and an integrated polarization splitter and optical switch are presented. Comparison with an existing simulation method is carried out for beam behavior within the bulk polarization converter. The effect of strong surface anchoring of a LC cell on the beam behaviors within the integrated switch is also demonstrated.

Journal Article↗

PubMed2005

Study of transmission response of edge filters employed in wavelength measurements.

The ratiometric wavelength-measurement system is modeled and an optimal design of transmission response of the employed edge filter is demonstrated in the context of a limited signal-to-noise ratio of the signal source. The corresponding experimental investigation is presented. The impact of the limited signal-to-noise ratio of the signal source on determining the optimal transmission response of edge filters for a wavelength-measurement application is shown theoretically and experimentally.

Journal Article↗