Biomedical subjects

FM Raymo

Publications and source records attributed to FM Raymo.

7 recordsLinked to original sources

PubMed2000

A

A solid state, electronically addressable, bistable [2]catenane-based molecular switching device was fabricated from a single monolayer of the [2]catenane, anchored with phospholipid counterions, and sandwiched between an n-type polycrystalline silicon bottom electrode and a metallic top electrode. The device exhibits hysteretic (bistable) current/voltage characteristics. The switch is opened at +2 volts, closed at -2 volts, and read at approximately 0.1 volt and may be recycled many times under ambient conditions. A mechanochemical mechanism for the action of the switch is presented and shown to be consistent with temperature-dependent measurements of the device operation.

Journal Article↗

PubMed2000

Tetrathiafulvalenenaphthalenophanes: planar chirality and cis/trans photoisomerization

A cyclophane incorporating one 1,5-dioxynaphthalene ring system and one tetrathiafulvalene (TTF) unit bridged by [SCH(2)CH(2)O] linkages has been synthesized. In this cyclophane, the TTF unit can adopt either cis or trans configurations. In addition, the 1, 5-dioxynaphthalene ring system imposes one element of planar chirality on this cyclophane. A second element of planar chirality is introduced by the trans form of the TTF unit. Thus, the cyclophane exists in diastereoisomeric forms as three pairs of enantiomers. The enantiomeric pairs associated with the cis form of the TTF unit, as well as one of those associated with the trans form, have been isolated by crystallization, and their structures assigned in the solid state by single-crystal X-ray analyses. In solution, cis/trans isomerization occurs when either the cis or the trans form of the cyclophane is exposed to light. The photoisomerization reaction can be followed by (1)H NMR and UV-vis spectroscopies, as well as by HPLC. The photoisomerization quantum yield has been measured at two different excitation wavelengths (406 and 313 nm). In both cases, the trans --> cis process (Phi = 0.20 at 406 nm) is much more efficient than the reverse cis --> trans process (Phi = 0.030 at 406 nm). Since the absorption spectra of the trans and cis isomers are different and the quantum yield of the trans --> cis photoisomerization reaction depends on the excitation wavelength, the mole fraction of the two diastereoisomers present at the photostationary state depends on the wavelength of the exciting light. No isomerization occurs when the solutions, regardless of the mole fraction of the two diastereoisomers, are stored in the dark.

Journal Article↗

PubMed2000

Self-complementary

Three [3]catenanes with cavities large enough to accommodate aromatic guests have been designed and synthesized (yields = 5-20 %) by means of kinetically controlled self-assembly processes. The X-ray structural analysis of one of three [3]catenanes confirmed the presence of a rectangular cavity (dimensions = 7 x 11 A) lined by pi-electron-rich recognition sites and hydrogen-bond acceptor groups. In spite of their apparently ideal recognition features, none of these [3]catenanes bind guests incorporating a pi-electron-deficient bipyridinium unit. However, the template-directed syntheses of the [3]catenanes also produce, in yields of 2-23%, [2]catenanes incorporating a 1,5-dioxynaphtho[38]crown-10 interlocked with a bipyridinium-based tetracationic cyclophane. The X-ray structural analyses of two of these [2]catenanes revealed that a combination of [pi...pi] and [C-H...pi] interactions is responsible for the formation of supramolecular homodimers in the solid state. 1H NMR spectroscopic investigations of the four [2]catenanes demonstrated that supramolecular homodimers are also formed (Ka= 17-31M(-1), T= 185 K) in (CD3)2CO solutions. Dynamic 1H NMR spectroscopy revealed that the 1,5-dioxynaphtho[38]crown-10 and tetracationic cyclophane components in the four [2]catenanes and in the three [3]catenanes circumrotate (deltaGc(not equal to) = 9-14 kcal mol(-1)) through each other's cavity in (CD3)2CO. Similarly, the 1,5-dioxynaphthalene and the bipyridinium ring systems rotate (deltaGc(not equal to) =10-14 kcal mol(-1)) about their [O...O] and [N...N] axes, respectively, in solution.

Journal Article↗

PubMed2000

The electrochemically-driven decomplexation/recomplexation of inclusion adducts of ferrocene derivatives with an electron-accepting receptor

The tetracationic cyclophane, cyclobis(paraquat-4,4'-biphenylene), binds 1,1'-disubstituted ferrocene-based polyethers as a result of (i) [pi...pi] stacking between the pi-electron-deficient bipyridinium units and the pi-electron-rich cyclopentadienyl rings and (ii) [C-H...O] hydrogen bonds between the alpha-bipyridinium hydrogen atoms and the polyether oxygen atoms. However, even the presence of a bulky tetraarylmethane group--which is too large to thread through the cavity of the cyclophane host--at the end of each of the two polyether substituents of the ferrocene-containing guest does not discourage adduct formation of the inclusion type. Thus, in these adducts, the ferrocene unit of the guest is located inside the cavity of the host with its two polyether chains protruding outward from the same side of the host. The alternative pseudorotaxane geometry is not observed in solutions of these 1:1 adducts. The host-guest adducts display absorption bands in the visible spectral region, characteristic of charge-transfer interactions. In the case of one of these adducts, reversible decomplexation/recomplexation takes place upon electrochemical oxidation/reduction of the ferrocene-based unit or upon reduction/oxidation of the tetracationic cyclophane.

Journal Article↗

PubMed2000

Switching of pseudorotaxanes and catenanes incorporating a tetrathiafulvalene unit by redox and chemical inputs

An acyclic polyether 1a, incorporating a central tetrathiafulvalene (TTF) electron donor unit and two 4-tert-butylphenoxy groups at its termini, has been synthesized. Two macrocyclic polyethers containing two different electron donors, namely a TTF unit with, in one case, a 1,4-dioxybenzene ring (2a), and, in the other case (2b), a 1,5-dioxynaphthalene ring system, have also been synthesized. These two macrocyclic polyethers have been mechanically interlocked in kinetically controlled template-directed syntheses with cyclobis(paraquat-p-phenylene) cyclophane (3(4+)) to afford the [2]catenanes 2a/3(4+) and 2b/3(4+), respectively. X-ray crystallography reveals that the [2]-catenane 2b/3(4+) has the TTF unit of 2b located inside the cavity of 3(4+). The spectroscopic (UV/vis and 1H NMR) and electrochemical properties of compounds 1a, 2a, 2b, 2a/3(4+), and 2b/3(4+) and of the [2]pseudorotaxane 1a.3(4+) were investigated. The absorption and emission properties of the mono- and dioxidized forms of the TTF unit in these various species have also been studied. The results obtained in acetonitrile solution can be summarized as follows. (a) While TTF2+ exhibits a strong fluorescence, no emission can be observed for the TTF2+ units contained in the polyethers and in their pseudorotaxanes and catenanes. (b) A donor-acceptor absorption band is observed upon two-electron oxidation of the TTF unit in the macrocyclic polyethers 2a and 2b. (c) The spontaneous self-assembly of 1a and 3(4+) to give the [2]pseudorotaxane 1a.3(4+) is strongly favored (Kass. = 5 x 10(5) L mol-1) but slow (at 296 K, k = 11.3 L mol-1 s-1 and delta G++ = 15.9 kcal mol-1) because of the steric hindrance associated with the bulky end groups of 1a. (d) In the pseudorotaxane 1a.3(4+), the reversible displacement of the cyclophane from the TTF unit in the threadlike substrate occurs on oxidation/reduction of its electroactive components. (e) Switching between the two translational isomers of the catenanes 2a/3(4+) and 2b/3(4+) occurs by cyclic oxidation and reduction of the TTF unit contained in 2a and in 2b, respectively. (f) Addition of o-chloroanil to the pseudorotaxane 1a.3(4+) and to the catenanes 2a/3(4+) and 2b/3(4+) causes the displacement of the TTF unit from the cavity of the cyclophane 3(4+) because of the formation of an adduct between the TTF unit and o-chloroanil.

Journal Article↗

PubMed2000

A Self-Complexing

A supramolecular homodimer is formed in solution and in the solid state by a self-complementary [2]catenane incorporating a 1,5-dioxynaphthalene-based macrocyclic polyether interlocked with a bipyridinium-based tetracationic cyclophane (shown schematically). This unique example of self-recognition is the result of a combination of cooperative pi small middle dot small middle dot small middle dotpi and C-H small middle dot small middle dot small middle dotpi interactions.

Journal Article↗

PubMed1999

Electronically configurable molecular-based logic gates

Logic gates were fabricated from an array of configurable switches, each consisting of a monolayer of redox-active rotaxanes sandwiched between metal electrodes. The switches were read by monitoring current flow at reducing voltages. In the "closed" state, current flow was dominated by resonant tunneling through the electronic states of the molecules. The switches were irreversibly opened by applying an oxidizing voltage across the device. Several devices were configured together to produce AND and OR logic gates. The high and low current levels of those gates were separated by factors of 15 and 30, respectively, which is a significant enhancement over that expected for wired-logic gates.

Journal Article↗