Biomedical subjects

F Lanni

Publications and source records attributed to F Lanni.

29 records · Page 2Linked to original sources

PubMed1985

Behavior of a fluorescent analogue of calmodulin in living 3T3 cells.

We have prepared and partially characterized a lissamine-rhodamine B fluorescent analogue of calmodulin, LRB-CM. The analogue had a dye/protein ratio of approximately 1.0 and contained no free dye or contaminating labeled proteins. LRB-CM was indistinguishable from native calmodulin upon SDS PAGE and in assays of phosphodiesterase and myosin light chain kinase. The emission spectrum of LRB-CM was insensitive to changes in pH, ionic strength, and temperature over the physiological range, but the apparent quantum yield was influenced somewhat by divalent cation concentration. LRB-CM injected into living Swiss 3T3 fibroblasts became associated with nitrobenzoxadiazole-phallacidin staining stress fibers in some interphase cells. LRB-CM and acetamidofluorescein-labeled actin co-injected into the same cell both became associated with fibers in some cells, but in most cases association of the two analogues with fibers was mutually exclusive. This suggests that calmodulin may differ from actin in the timing of incorporation into stress fibers or that we have distinguished distinct populations of stress fibers. We were able to detect no direct interaction of LRB-CM with actin by fluorescence photobleaching recovery (FRAP) of aqueous solutions. Interaction of LRB-CM with myosin light chain kinase also was not detected by FRAP. This suggests that the mean lifetime of the calmodulin-myosin light chain kinase complex is too short to affect the diffusion coefficient of calmodulin. We examined various fluorescent derivatives of proteins and dextrans as suitable control molecules for quantitative fluorescent analogue cytochemistry in living cells. Fluorescein isothiocyanate-dextrans were found to be preferable to all the proteins tested, since their mobilities in cytoplasm were inversely dependent on molecular size and there was no evidence of binding to intracellular components. In contrast, FRAP of LRB-CM in the cytoplasm of living 3T3 cells suggested that the analogue interacts with intracellular components with a range of affinities. The mobility of LRB-CM in the cytoplasm was sensitive to treatment of the cells with trifluoperazine, which suggests that at least some of the intracellular binding sites are specific for calmodulin in the calcium-bound form. FRAP of LRB-CM in the nuclei of living 3T3 cells indicated that the analogue was highly mobile within the nucleus but entered the nucleus from the cytoplasm much more slowly than fluorescein isothiocyanate-dextran of comparable molecular size and much more slowly than predicted from its mobility in cytoplasm.

Actins↗

PubMed1984

Detection and characterization of actin monomers, oligomers, and filaments in solution by measurement of fluorescence photobleaching recovery.

Fluorescence photobleaching recovery (FPR) was measured to determine the diffusion coefficient of fluorescein-labeled G-actin in low-salt buffer. The result obtained, 7.15 +/- 0.35 X 10(-7) cm2/s, is in good agreement with that computed from the molecular weight, partial specific volume, and sedimentation coefficient, but is higher than previously obtained values. It is demonstrated from theory that at low ionic strength, the electrostatic contribution to the intrinsic viscosity leads to an overestimate of the hydrodynamic eccentricity of G-actin. Data from FPR, sedimentation, and fluorescence polarization experiments all indicate that the true low-salt form of the actin monomer has an axial ratio less than or equal to 3.0. The G-F transformation of actin was also observed by measurement of FPR during the assembly phase, in the steady state, and in the presence of ligands such as cytochalasin and aldolase. Each FPR record in general yields three data: relative proportion of rapidly and slowly diffusing actin, diffusion coefficient for the high-mobility fraction, and a mean diffusion coefficient for the low-mobility fraction. A relation between the mean low-mobility diffusion coefficient and the number-average filament length is derived and applied to the analysis of FPR data. Under typical conditions, the average filament length was much greater than 10 micron in the steady state. Cytochalasin D was found to decrease filament length and total amount of filament proportionally; total filament number was not greatly affected. In all polymerizations of G-actin, the high-mobility material observed in situ was found to be essentially monomeric actin. Relatively stable oligomers of actin were separated by fractionating G-AF-actin by gel filtration in 50 microM MgCl2 at 4 degrees C. On the basis of the diffusion coefficient, we conclude that monomer and dimer constitute the major particle types present under these conditions. Sedimentation of labeled actin polymerized in 1.0 mM MgCl2 yielded a graded supernatant that contained actin oligomers significantly larger than the monomer.

Actins↗

PubMed1984

A method for incorporating macromolecules into adherent cells.

We describe a simple method for loading exogenous macromolecules into the cytoplasm of mammalian cells adherent to tissue culture dishes. Culture medium was replaced with a thin layer of fluorescently labeled macromolecules, the cells were harvested from the substrate by scraping with a rubber policeman, transferred immediately to ice cold media, washed, and then replated for culture. We refer to the method as "scrape-loading." Viability of cells was 50-60% immediately after scrape-loading and was 90% for those cells remaining after 24 h of culture. About 40% of adherent, well-spread fibroblasts contained fluorescent molecules 18 h after scrape-loading of labeled dextrans, ovalbumin, or immunoglobulin-G. On average, 10(7) dextran molecules (70,000-mol wt) were incorporated into each fibroblast by scrape-loading in 10 mg/ml dextran. The extent of loading depended on the concentration and molecular weight of the dextrans used. A fluorescent analog of actin could also be loaded into fibroblasts where it labeled stress fibers. HeLa cells, a macrophage-like cell line, 1774A.1, and human neutrophils were all successfully loaded with dextran by scraping. The method of scrape-loading should be applicable to a broad range of adherent cell types, and useful for loading of diverse kinds of macromolecules.

Animals↗

PubMed1982

Mobility of cytoplasmic and membrane-associated actin in living cells.

We have combined fluorescent analogue cytochemistry with fluorescence photobleaching recovery to measure the mobility of fluorescently labeled actin and other labeled test proteins microinjected into living amoebae. Bovine serum albumin, ovalbumin, and ribonuclease A have a cytoplasmic mobility, expressed as a diffusion coefficient, that is 1/2 to 1/3 of that observed in aqueous solution; 90% of the actin has a mobility 1/2 to 1/8 of that of G-actin in aqueous solution, and approximately equal to 10% of the actin has a mobility comparable to that of F-actin in aqueous solution. Therefore, no more than 10% of the actin in the cytoplasm of amoebae can exist as static filaments. Microinjection of phalloidin decreases the diffusion coefficient of the mobile component of cytoplasmic actin, and it also increases the low-mobility fraction to 50% but has no effect on the mobility of labeled ovalbumin. By comparing the mobility of actin in different parts of amoebae and by separating cytoplasm from plasmalemma-ectoplasm, we found the low-mobility fraction of actin to be enriched in the tail, along the plasmalemma-ectoplasm, and in contracted cytoplasm.

Actins↗

PubMed1981

Fluorescence photobleaching recovery in solutions of labeled actin.

We have demonstrated that the technique of fluorescence photobleaching recovery (FPR) can be used to examine the state of a single component in complex self-assembling macromolecular systems. Polymerization of actin, initiated by addition of salt or Mg+2 to a low-ionic-strength solution of G-actin, has been observed by sequential measurement of FPR with the aid of fluorescein-labeled actin. Solutions of actin which had been labeled using 5-iodoacetamido fluorescein (5-IAF) showed anomalous recovery of fluorescence above the initial value, which indicates a photoinduced increase in local polymerization. No such anomaly was observed with actin that had been labeled with fluorescein isothiocyanate (FITC). The FPR data are directly interpretable in terms of the fraction of labeled protein that is immobilized in the supramolecular assembly and in terms of the average diffusion coefficient of the mobile fraction. Our data are consistent with the "treadmill" model of actin polymerization, in that they show that actin is present under polymerizing conditions either as a high polymer or as monomer or low oligomer. We believe that the FPR technique can be applied to the study of many types of reconstituted motile or cytoskeletal systems in vitro or in vivo.

Actins↗

PubMed1966

Bacteriophage T5 chromosome fractionation: genetic specificity of a DNA fragment.

The bacteriophage T5 DNA fragments retained by a population of blended early complexes, formed under conditions of limited viral DNA transfer to host cells, appear to include only one of six tested cistrons. When complexes harboring wild-type fragments are infected with appropriate amber mutants, recombination occurs but apparently is not needed for productive infection.

DNA, Viral↗

PubMed1966