Search PubMed⌕ Search

Biomedical subjects

E K Hansen

Publications and source records attributed to E K Hansen.

At least 19 recordsLinked to original sources
PubMed1992

Dentin hypersensitivity treated with a fluoride-containing varnish or a light-cured glass-ionomer liner.

Dentin hypersensitivity in 112 teeth was randomly treated with Duraphat or Vitrabond. No patients were included unless they, without being asked, complained about daily pain for a long period of time caused by cold, warm, sweet, sour, touch or any combination of these five variables. Patients were excluded if the dentin hypersensitivity could have been caused by cervical abrasion/erosion lesions deeper than 1 mm, cracked-tooth syndrome, caries lesions, operative caries treatment, and/or periodontal surgery or root scaling within the last 6 months. The pain was registered on a binary scale: 1) pain before the treatment; and 2) pain/no pain after the treatment. With Duraphat, 22% of the treatments failed within 1 wk and the cumulative 1-yr success rate was 41%. With Vitrabond, 2% failed within the first week and the 1-yr success rate was 79%. The difference between the two treatments was highly significant. Patients in whom Duraphat failed were treated with Vitrabond and vice versa; the 1-yr success rate for the retreated teeth was 68% when "Duraphat-failures" were treated with Vitrabond and 42% when "Vitrabond-failures" were treated with Duraphat.

Adult↗
PubMed1992

Five-year study of cervical erosions restored with resin and dentin-bonding agent.

The cumulative retention rate of a microfilled resin in non-undercut cervical abrasion/erosion lesions was studied over a 5-yr period. The enamel was etched and the dentin was pretreated with either Gluma (n = 75) or the first marketed version of Scotchbond (n = 30). The cumulative 5-yr retention rate of the Gluma fillings was 90% and that of the Scotchbond fillings 47% (the 95% confidence limits were 83-98% for Gluma fillings and 27-67% for Scotchbond fillings). The retention rate with both bonding agents was significantly higher in the maxillary arch than in the mandibular arch.

Acid Etching, Dental↗
PubMed1991

Influence of the solubility parameter of intermediary resin on the effectiveness of the gluma bonding system.

The aim of the present study was to investigate the effect of the solubility parameter of the intermediary resin in the Gluma system on the bonding to dentin. The solubility parameter of the resins was varied between 18.8 x 10(3) and 21.1 x 10(3) J(1/2)/m3/2 by varying the composition of the resin. The efficacy of the bonding system was determined by measurements of marginal gaps formed by polymerization contraction of a restorative resin in dentin cavities treated with the bonding system. The bonding system had maximum efficacy at a solubility parameter of the intermediary resin of delta = 20.0 x 10(3) J(1/2)/m3/2. This finding corroborates a concept of bonding to dentin that involves a mechanical interlocking by interpenetrating resins.

Analysis of Variance↗
PubMed1990

Marginal adaptation of resin in relation to application technique and use of a calcium hydroxide liner.

The marginal adaptation of a restorative resin was examined in cone-shaped cavities prepared in extracted human teeth. The use of a thin layer of a Ca(OH)2 liner in the bottom of the cavities did not influence the wall-to-wall (wtw) polymerization contraction and it did not affect the gap-reducing efficacy of a dentin-bonding agent. The wtw contraction was markedly increased when the restorative resin was applied in two layers parallel to the free surface of the cavity; the reason for this is supposed to be that the ratio between the volume of the filling (V) and the area of the cavity wall (A) is increased for the second layer compared to the V/A ratio found in cavities filled with one increment.

Bisphenol A-Glycidyl Methacrylate↗
PubMed1990

In vivo fractures of endodontically treated posterior teeth restored with amalgam.

The cumulative survival rate (retention of both cusps) and the fracture pattern of 1639 endodontically treated posterior teeth were assessed in a retrospective study. All teeth had an MO/DO or an MOD cavity restored with amalgam without cuspal overlays. The 20-year survival rate of teeth with an MO/DO cavity was markedly higher than that of teeth with an MOD cavity. The lowest survival rate was found for the upper premolars with an MOD cavity: 28% of these teeth fractured within 3 years after endodontic therapy, 57% were lost after 10 years, and 73% after 20 years. Generally, the cusp most prone to fracture was the lingual one, and lingual fractures caused significantly more damage to the periodontal tissues than did facial or total crown fractures. The severity of periodontal damage increased with posterior location of the tooth. By far the most serious failures, irrespective of the cavity type, were found for the upper second molar, as 10 of 29 fractures led to extraction. It is concluded that amalgam, especially in MOD cavities, is an unacceptable material for restoration of endodontically treated posterior teeth if used without cuspal overlays.

Analysis of Variance↗
PubMed1990

In vivo fractures of endodontically treated posterior teeth restored with enamel-bonded resin.

The cumulative survival rate of 190 endodontically treated posterior teeth were assessed in a retrospective study; all teeth had an MO/DO or an MOD cavity restored with a composite resin without cuspal overlays after previous acid-etching of the enamel. In contrast to our previous study on endontically treated posterior teeth restored with amalgam, the survival rate of the MOD resin-restored teeth was equal to that of MO/DO teeth. Teeth restored with a light-activated resin had a much lower survival rate than teeth restored with a chemically-activated material, the cause presumably being that the light-activated resins were insufficiently irradiated. Nearly 25% of the teeth had been restored with a microfilled resin for anterior use and these teeth had a lower survival rate than had teeth restored with a macrofilled or hybrid resin. It was also found that a beveling technique did not decrease the fracture rate while the use of an intermediate layer of low-viscosity resin resulted in a significant improvement.

Bicuspid↗
PubMed1989

Saliva contamination vs. efficacy of dentin-bonding agents.

The efficacy of two dentin-bonding agents (Gluma and Scotchbond Dual Cure) was investigated in vitro with or without saliva contamination of the dentin before or after application of the adhesive. The efficacy of the bonding agents was evaluated by a shear-bond strength test and a cavity test. When the dentin surface was contaminated, either before or after application of one of the bonding agents, the shear bond strength was reduced, but the difference between contaminated and non-contaminated specimens was not statistically significant. In the cavity test, the width and the extent of the marginal contraction gap were markedly increased when the dentin was contaminated with saliva before the bonding agent was applied. If the contamination happened after application of the adhesive, the efficacy of Gluma was further reduced, while that of Scotchbond was significantly improved. (This phenomenon has been investigated in detail in an accompanying paper.) The clinical consequence of saliva contamination seems to be that when Gluma is used as dentin-bonding agent, the contaminated area must be removed operatively, and then each of the various bonding procedures must be repeated.

Dental Bonding↗
PubMed1989

Improved efficacy of some phosphate-based dentin-bonding agents.

The gap-reducing efficacy of four phosphate-based dentin-bonding agents was tested after various treatments of the dentin and/or the bonding agents. The investigation was carried out on extracted human teeth. One of the root surfaces was ground flat, and a cylindrical butt-joint cavity was prepared in the ground dentin surface. It was found that the efficacy of two of the adhesives, presumably being chloro-substituted phosphates, could be markedly improved if the primed dentin was rinsed with copious amounts of water, dried by compressed air, and a second layer of bonding agent applied. The mechanism behind this improvement is assumed to be the formation of hydrogen chloride, which dissolves part of the smear layer.

Dental Bonding↗
PubMed1989

Marginal adaptation of posterior resins: effect of dentin-bonding agent and hygroscopic expansion.

The wall-to-wall polymerization contraction of three composite resins, provisionally accepted by the American Dental Association for use in posterior teeth, was investigated in dentin cavities prepared in extracted human teeth. The marginal adaptation was measured in a light microscope 10 min after polymerization or after 28 days of water absorption. The three composites were tested with and without previous application of two dentin-bonding agents. Used as the control was a microfilled resin intended for use in anterior teeth. None of the two dentin-bonding agents could prevent the formation of a contraction gap of any of the four resins, but the results obtained with the anterior material were significantly better than those obtained with the posterior resins. The reason for the low efficacy of the dentin-bonding agents, when used with the posterior resins, is assumed to be the high viscosity of these restoratives, caused by both the high quantity of fillers and the composition of the organic components. As to the hygroscopic expansion, the contraction gaps of the anterior resin were closed within 28 days, while the posterior materials all had a residual gap. The reason for the smaller hygroscopic expansion of the posterior resins is assumed to be related to the reduced quantity of organic material in these composites.

Absorption↗
PubMed1989

Three-year study of cervical erosions restored with resin and dentin-bonding agent.

Cervical erosions without undercuts and traditional cavity preparation were restored with a light-activated microfilled resin in combination with two different dentin-bonding agents, Gluma and the chemically activated version of Scotchbond. In the Gluma group the final polishing was postponed for at least 1 day; in the Scotchbond group polishing was performed 5 to 15 min after polymerization. The results of the two clinical tests are therefore not comparable. Under these experimental conditions the cumulative 3-year survival rate for the fillings in the two groups were 96% (Gluma) and 66% (Scotchbond). It is concluded that cervical erosions should be restored without undercuts or traditional cavity preparation on the condition that the enamel is acid-etched, polishing of the gingival area is postponed, and an effective dentin-bonding agent is used.

Acid Etching, Dental↗
PubMed1989

Efficacy of dentin-bonding agents in relation to application technique.

The gap-reducing efficacy of two dentin-bonding agents was examined in butt-joint dentin cavities prepared in extracted human teeth. The cavity wall and the surrounding dentin surface were treated with one of the dentin-bonding agents, and a light-activated microfilled restorative resin was either applied and polymerized or applied and then withdrawn from the cavity and once again applied before polymerization. Ten minutes after polymerization the width and the extent of the contraction gap were measured, using a light microscope, approximately 0.1 mm below the original free surface of the fillings. The marginal porosity was also registered and calculated in percentage of the total filling periphery. It was found that reapplication resulted in an increased marginal porosity and also that the width and extent of the contraction gap were increased when the restorative resin was reapplied.

Adhesives↗
PubMed1988

Effect of postponed polishing on marginal adaptation of resin used with dentin-bonding agent.

Dentin cavities, prepared in extracted human teeth, were treated with two different dentin-bonding agents and filled with a light-activated microfilled resin. The maximum width of the contraction gap (MG) and the extent of the gap (GP) were then measured, using a light microscope, approximately 0.1 mm below the original free surface of the filling. The contraction gap was measured 30 s, 10 min or 60 min, and remeasured 65 min, after stop of irradiation. A positive correlation was found between the two variables, MG and GP. The product of MG and GP was chosen as basis for the statistical analyses. This "marginal index" was significantly reduced when polishing of the marginal area was postponed for 10 min with one of the dentin-bonding agents and for 60 min with the other. Even though the improvement in marginal adaptation was statistically significant, this improvement was considered clinically irrelevant. It is concluded that polishing of the marginal area should not be done before the hygroscopic expansion of the resin restoration has closed the contraction gap.

Chemical Phenomena↗