Search PubMed⌕ Search

Biomedical subjects

E F Brès

Publications and source records attributed to E F Brès.

7 recordsLinked to original sources

Surface structure study of biological calcium phosphate apatite crystals from human tooth enamel.

A surface-structure study of human tooth enamel crystals has been carried out by high-resolution electron microscopy (HREM). The surfaces of several crystals have been examined and the surfaces of a single crystal are described here. The observations made on this crystal are similar to the observations made on the other crystals, although the difference of morphology in the crystals observed indicates that the growth control by matrix proteins takes only place on the [011 macro 0] surfaces of the crystals. The crystal described here is oriented along the [112 macro 0] direction, and the following surfaces have been analyzed: (11 macro 00), (011 macro 1), (01 macro 11) and (0001). A subsurface reconstruction is observed just below the surface of the crystal not bonded to the matrix and lying above the supporting film. Observation of the matrix surrounding the crystal shows the existence of poorly crystalline phases with a structure close to that of hydroxyapatite (OHAP). Finally, a comparison of the images of the (011 macro 0) surface with computer-simulated images calculated for several models of the OHAP surface structure shows that the surface itself is stoichiometric and contains both calcium and phosphate groups. The knowledge of the binding sites of proteins on biomineral crystals such as the ones found in human tooth enamel is of prime importance for the understanding of their growth process. In this study, the first structure determination of the surface of human tooth enamel crystals is presented.

Apatites↗

Study of interface phenomena between bone and titanium and alumina surfaces in the case of monolithic and composite dental implants.

The interface between mandibular bone and dental implants was examined with the in vivo dog model. Implant/bone interfaces were investigated for three types of materials: Ti-30 wt% Ta/Al2O3, titanium and Al2O3 using microscopy techniques covering a large magnification range: scanning electron microscopy, transmission electron microscopy, energy dispersive X-ray analysis and Auger spectroscopy. During the interaction of the Al2O3 ceramic with bone, an interfacial layer about 15 microm thick is formed. The same phenomenon was observed at the titanium bone interface, where the thickness of the layer was about 10 microm. In all cases, interface layers were sharp with well-defined borders between bone tissue and implant materials. No calcification took place inside the interface layer. A chemical analysis performed on this layer shows the presence of titanium, calcium and phosphorus in the case of titanium implants, and aluminium, calcium and phosphorus in the case of alumina implants. A rapid decrease in metal composition with increasing distances from the implant surface is correlated to a slow increase in calcium and phosphorus in the direction of the bone. Direct contact between implant and bone was observed. No biocorrosive effects were detected at the Ti-30 wt% Ta/Al2O3 metal-ceramic interface.

Journal Article↗

Space-group determination of human tooth-enamel crystals.

In the present work, we have determined the space group of human tooth-enamel crystals using--for the first time for a biological crystal--convergent beam electron diffraction (CBED). The symmetries observed in the different patterns we have obtained lead us to the P6(3)/m hydroxyapatite space group. Disorder, most likely situated in the columns formed by the hydroxyl ions of the crystals, is suggested as a cause of weak intensity in the otherwise forbidden 000l (l odd) reflections and low visibility of first-order Laue zone (FOLZ) reflections in the CBED pattern from crystals oriented along the [0001] zone axis. A monoclinic phase was not observed.

Adult↗

HREM study of irradiation damage in human dental enamel crystals.

Several phenomena have been observed during the examination of human dental enamel crystals (mainly constituted by hydroxyapatite (OHAP] by high-resolution electron microscopy (HREM) at 300 and 400 keV: orientation-dependent damage in the form of mass loss from voids or uniform destruction of crystal structure, beam-induced diffusion creating outgrowths at the crystal surfaces, recrystallization of the bulk crystal and crystallization of the inorganic components of the matrix surrounding the crystals. These beam-induced crystals have the CaO structure. The phenomena observed are most likely due to various electron-crystal interaction mechanisms (ballistic knock-on damage, electronic excitations, temperature rise, etc.). In this paper, the contribution of the ballistic process to the phenomena observed is discussed. The quantitative description of the knock-on collisions rests on the McKinley-Feshbach cross-section formula. The minimum ion displacement energies which appear in this expression have been estimated on the basis of the electrostatic ion binding energies, and the covalent bond energies if required. It is shown that hydroxyl, calcium and oxygen ions can effectively be displaced by the incident 300 and 400 keV electrons. Thus, the formation of CaO crystals by the combination of calcium and oxygen ions diffusing from their initial sites inside the OHAP lattice can tentatively be explained.

Adult↗

Compositional variations in apatites with respect to preferential ionic extraction.

Detection of ionic losses from the apatitic structure (Ca10(PO4)6(OH)2) by high-resolution electron microscopy was investigated theoretically. Linear image analysis showed the need for an objective aperture of at least 3.7 nm-1 to visualize four different coordinates (CaII, OH-, P and mid-point between CaII-P bond). High-resolution image analysis and plotting of OH- column intensity against specimen thickness showed an inverse proportionality between composition and OH- image intensities for very thin specimens (less than 2 nm). Image intensity variation would be detectable experimentally, but the preparation of such thin specimens by ultramicrotomy is impossible.

Apatites↗

High-resolution electron microscopy of human enamel crystals.

The structure of enamel crystals obtained from four human premolars has been studied by high-resolution electron microscopy (HREM) in the [0001], [2110], [1540], [0110] and [1213] crystallographic directions at various microscope defocus and crystal thickness values. The resolution obtained has not previously been reported for human enamel crystals. In all cases, it was possible to match the experimental images to images calculated using the atomic positions of mineral hydroxyapatite. However, a deviation from hexagonal symmetry characterized by marked (1010) planes of intensity different from the one of the (3030) and (1010)-type planes was observed. In this work, we present an improvement of Scherzer resolution of 0.25-0.20 nm over previous work on biological enamel crystals. This improvement of resolution has permitted the incorporation of crystallographic reflections of higher spatial frequencies into the imaging process of the microscope and has led to a more precise structure determination of the crystals studied.

Adult↗

Theoretical detection of a dark contrast line in twinned apatite bicrystals and its possible correlation with the chemical properties of human dentin and enamel crystals.

Electron microscope images of twinned apatite bicrystals oriented along the [1120] crystallographic direction have been simulated for various experimental conditions, and the validity of the calculation has been checked. These images show a dark contrast line similar to the one observed experimentally in enamel and dentin crystals and therefore strongly suggest the presence of a twin plane parallel to the (1100) crystallographic planes, in these crystals. The presence of a twin boundary in teeth and bone crystals is of prime importance for the adsorption and the dissolution properties of the calcified tissues as a whole.

Apatites↗