Biomedical subjects

Daniel P Brennan

Publications and source records attributed to Daniel P Brennan.

3 recordsLinked to original sources

PubMed2006

Microfabrication using elastomeric stamp deformation.

Elastomeric stamp deformation has been utilized for the contact printing (CP) of self-assembled monolayers (SAMs) and, more recently, polymers and proteins. Here, we take advantage of this well-studied phenomenon to fabricate a series of new metal thin-film patterns not present on the original stamp. The rounded patterns are of nanoscale thickness, long-range order, and are created from elastomeric stamps with only straight-edged features. The metal was printed onto the surface of an alpha,omega-alkanedithiol self-assembled monolayer (SAM). The new shapes are controlled by a combination of stamp geometry design and the application of external pressure. Previously published rules on stamp deformation for contact printing of SAMs are invalid because the coating is instead a thin-metal film. This method represents a new pathway to micropatterning metal thin films, leading to shapes with higher complexity than the original lithographic masters.

Journal Article↗

PubMed2005

Swollen poly(dimethylsiloxane) (PDMS) as a template for inorganic morphologies.

We report a series of silica, titania, and zirconia microstructures synthesized within swollen poly(dimethylsiloxane) (PDMS). Voids created by solvent-swelling the polymer are used to template the product. The inorganic morphologies range from spheres to networks, depending upon the nature of the polymer, its degree of swelling, and the synthetic conditions. Organic solvents as well as pure metal alkoxide liquids have been used to swell the polymer. Once the alkoxide precursor is inside the swollen polymer, water is introduced to bring about hydrolysis and condensation polymerization. The product is a textured metal oxide within a PDMS matrix. Scanning electron microscopy (SEM), optical microscopy, nuclear magnetic resonance (NMR), and powder X-ray diffraction (PXRD) were used to characterize the products. Microstructures formed in this manner have potential use as an inexpensive route to catalysts, fillers, capsules, or membranes for separations.

Microscopy, Electron, Scanning↗

PubMed2005

Open metal-organic framework containing cuprate chains.

A three-dimensional Cu(II) metal-organic framework, copper hydroxide p-pyridinecarboxylate hydrate, [Cu(OH)(C5H4NCO2).H2O], was synthesized by hydrothermally reacting copper nitrate with p-pyridinecarboxylic acid. The crystals were suitable for single-crystal X-ray diffraction analysis, which showed that the Cu(II) centers adopt a slightly distorted square pyramidal geometry. They coordinate to both the pyridyl and carboxylate functionalities of the pyridinecarboxylate bridging ligands. Infinite copper oxide chains run through the structure and are connected by p-pyridinecarboxylate (p-PyC) ligands. Crystal data: monoclinic, space group P2(1)/n, a = 3.5521(2) A, b = 15.8665(11) A, c = 12.9977(9) A, beta = 95.285(2) degrees , and Z = 4. Thermogravimetric analysis (TGA) revealed that the guest H2O molecules in the channels may be removed, and the material is stable to ca. 245 degrees C. Magnetic measurements indicated the material has one-dimensional (1D) antiferromagnetic ordering within the Cu2+ chains with a Néel temperature of ca. 51 K. Data fitting to the Bonner-Fisher model yielded a coupling constant, J, of -7.3 cm(-1) and g factor of 2.15. The Curie tail below 20 K is due to a small amount of paramagnetic impurities, calculated to be approximately 0.2% in concentration. Further characterization of crystallinity and morphology are discussed, including powder X-ray diffraction (PXRD), elemental analysis, and optical microscopy.

Journal Article↗