Biomedical subjects

D P Egolf

Publications and source records attributed to D P Egolf.

10 recordsLinked to original sources

PubMed1993

Quantifying ear-canal geometry with multiple computer-assisted tomographic scans.

Several audiological tests require knowledge of the sound-pressure spectrum at the eardrum. However, microphone readings are typically made at another, more-accessible position in the auditory canal. Recordings are then "adjusted" to the plane of the eardrum via mathematical models of the ear canal and eardrum. As bandwidths of audiological instruments have increased, ear-canal models have, by necessity, become more precise geometrically. Reported herein is a noninvasive procedure for acquiring geometry of the ear canal in fine detail. The method employs a computer-assisted tomographic (CAT) scanner in two steps to make radiographic images of parasagittal cross sections at uniform intervals along the lateral length of the canal. Accuracy was evaluated by comparing areas of cross sections appearing in radiographic images of a cadaver ear canal to cross sectional areas of corresponding michrotome slices of an injection mold of the same canal. Percent differences between these two areas had a mean value of 9.65% for 26 different cross sections of the one ear canal studied. Ear canal volume estimated from the CAT images was 6.12% different from the estimated volume of the injection mold: an improvement over the reported 39% maximum error of conventional acoustic volume measurements.

Acoustic Stimulation↗

PubMed1993

Measurements of acoustic impedance at the input to the occluded ear canal.

Multi-frequency (multi-component) acoustic impedance measurements may evolve into a sensitive technique for the remote detection of aural pathologies. Such data are also relevant to models used in hearing aid design and could be an asset to the hearing aid prescription and fitting process. This report describes the development and use of a broad-band procedure which acquires impedance data in 20 Hz intervals and describes a comparison of data collected at two sites by different investigators. Mean data were in excellent agreement, and an explanation for a single case of extreme normal variability is presented.

Acoustic Impedance Tests↗

PubMed1992

Occluded-ear simulator with variable acoustic properties.

Ear simulators were designed to replicate acoustical characteristics of the average adult ear. Due to variability of ear-canal geometry and eardrum impedance among individuals, the possibility of any one person exhibiting such "average" characteristics--especially if that person is a child and/or has a conductive pathology--is remote. Thus, ear simulators have been of only peripheral value when prescribing a hearing aid (a high output impedance device) to fit the acoustical requirements of a particular patient. Reported herein is development of a programmable artificial ear (PAE) that can account for individual differences in ear-canal geometry and eardrum impedance. It consists of a 2.0-cc coupler, microphone, amplifier, computer, PAE code, and a computer card and/or software for digitization and Fourier transformation. Required input data includes ear-canal dimensions, eardrum impedance, and output impedance of the hearing aid being tested. Sound-pressure recordings produced in the 2.0-cc coupler by the hearing aid are adjusted by the computer to what they would have been had the recordings been made at the eardrum of a particular patient wearing the same hearing aid. Good agreement was observed between experiment and theory for one test case involving a totally occluding miniature earphone.

Acoustic Impedance Tests↗

PubMed1989

Simulating the open-loop transfer function as a means for understanding acoustic feedback in hearing aids.

Suppressing unstable acoustic feedback in hearing aids will first require knowledge of the open-loop transfer functions of such systems. Reported herein is a mathematical technique for simulating the open-loop transfer function of an in situ eyeglass-type hearing aid. In particular, a computer program was developed that characterized the hearing aid as a serial connection of two-port blocks, each representing one individual component of a hearing aid. Included, for example, were two-port blocks representing the microphone, amplifier, receiver, sound tubes leading to the eardrum (including the ear canal itself), earmold vent, and external pathway from the vent outlet back to the microphone. The computer program was validated by replicating laboratory data derived from an experiment involving a nonstandard manikin fitted with a nonstandard artificial ear. Next, the open-loop transfer function of an eyeglass-type hearing aid in situ on the manikin was simulated via the computer program. Unfortunately, those computer-generated data were not replicated in the laboratory due to the difficulty encountered in actually measuring the open-loop transfer function. Nevertheless, investigators were able to utilize those data to predict, within +/- 25 Hz, the "squeal" frequency of unstable acoustic feedback.

Acoustics↗

PubMed1988

Experimental determination of cascade parameters of a hearing-aid microphone via the two-load method.

Presented in this article is a computer-aided experimental method for obtaining the cascade parameters of the two-port model of a miniature hearing-aid microphone. The method is an adaptation of the "two-load" method [D.P. Egolf and R.G. Leonard, J. Acoust. Soc. Am. 62, 1013-1023 (1977)] to acoustoelectric, rather than electroacoustic, transducers. The cascade parameters of a particular microphone, determined by this method, were within 2.5 dB of the manufacturer's published open-circuit sensitivity data. In an attempt to further verify the numerical cascade-parameter data, a two-port model of the microphone was used to simulate experimental voltages developed across two different complex electrical load impedances attached to the microphone. The results showed experimental/simulation differences of no greater than 3.0 dB at any frequency. The two-port microphone model and associated cascade parameters are currently being incorporated into a computer-based plan for mathematical simulation of an entire in situ hearing aid.

Electronics↗

PubMed1988

A technique for simulating the amplifier-to-eardrum transfer function of an in situ hearing aid.

There are numerous articles wherein mathematical models of various parts of an in situ hearing aid have been reported. Such parts include, for example, the microphone, receiver, cylindrical tubes carrying sound to the eardrum and out through the earmold vent, and the external path from the vent back to the microphone. This article extends these earlier works to include the hearing-aid amplifier. In particular, a mathematical technique for characterizing the amplifier in combination with the receiver is reported. Cascade parameters of a two-port model of one particular amplifier/receiver combination are obtained by this method. The cascade-parameter data and the method of obtaining this data are verified by two different experimental procedures. One procedure involves both computing and measuring the input driving-point impedance of the amplifier/receiver combination. In the second procedure, the amplifier-to-eardrum transfer function of a hearing aid incorporating this same amplifier/receiver combination and mounted on an artificial ear is both computed and measured. Experimental and computed values of this transfer function for three different earmold geometries are in reasonably close agreement. The amplifier/receiver model reported herein will be used in future studies of acoustic feedback in hearing aids.

Amplifiers, Electronic↗

PubMed1986

The constant-volume-velocity nature of hearing aids: conclusions based on computer simulations.

In the literature there are several references which imply that various parts of a hearing aid are sources of constant volume velocity. Reported herein are the findings of an investigation of the validity of such statements. A computer scheme, referenced elsewhere, for modeling in situ hearing aids was utilized to test the constant-volume-velocity hypothesis. In particular, capabilities of the receiver, ear hook, and earmold tip to deliver constant volume velocity were investigated via a computer. To facilitate such an investigation, a universal receiver/earmold model was created. This model was broken down into "source" and "load"at three locations: the receive output, output of the ear hook, and medial tip of the earmold. At each location comparisons were made between computed values of source and load impedance. The constant-volume-velocity hypothesis was assumed to be valid for those cases where source impedance was much, much greater than load impedance. Plots of such impedances show that, for the cases investigated, this rarely occurred, except over certain frequency bands. With the exception of in-the-ear hearing aids, these results appear to contradict inferences made in the literature about the constant-volume-velocity nature of hearing aids.

Acoustics↗

PubMed1985

The hearing aid feedback path: mathematical simulations and experimental verification.

Acoustic feedback in hearing aids has received little attention in the literature. Feedback occurs when stability conditions of the open-loop transfer function of an in situ hearing aid are violated. Solving the feedback problem will first require knowledge of the open-loop transfer function. Included in the open-loop transfer function is the acoustical path by which sound emanating from the earmold vent returns to the microphone (i.e., the feedback path). Reported herein are two different mathematical procedures for simulating transfer functions of the feedback path of an eyeglass-type hearing aid. In one procedure the vent exit was modeled as a point source of sound located on a flat plane, while it was treated as a point source on a sphere in the other. Results of laboratory experiments indicate that the mathematical models accurately predict those acoustic phenomena for which they were intended: point sources on plane and spherical baffles. Results of manikin experiments showed both models to be less accurate for simulating the feedback path around the human head. The maximum difference between experiment and theory was 6 dB at one frequency. Surprisingly, the flat-baffle model produced better agreement with experimental results than did the sphere model.

Acoustics↗

PubMed1985

Effects of normal and pathologic eardrum impedance on sound pressure in the aided ear canal: a computer simulation.

Reported herein are results of computer simulations of aided sound spectra in ears with normal and pathologic eardrum impedance. The computer technique used in this study has been reported elsewhere [D. P. Egolf, D. R. Tree, and L. L. Feth, J. Acoust. Soc. Am. 63, 264-271 (1978)]. Consequently, to develop reader confidence in the computer scheme, its application to real ears was first tested. This was accomplished by (1) comparing computed spectral data with in-the-ear measurements and (2) comparing real ear minus 2-cc coupler data-both computer generated--with an idealized difference curve published elsewhere [R. M. Sachs and M. D. Burkhard, unpublished rep. no. 20022-1, Industrial Research Products, Inc., Elk Grove Village, IL (1972)]. Results indicate that the wide variation in eardrum impedance among normals evidenced in other studies produces a corresponding wide variation in aided spectrum shape. Likewise, simulations utilizing two sets of pathologic eardrum impedance data obtained from the literature show that aided sound spectra in such ears are likely to be significantly different from those occurring in normal ears. These findings suggest, as others have concluded, that there may be a substantial variation in spectrum shape among individuals wearing identically the same hearing aid--even if those individuals have normal hearing. In conclusion, questions are raised about the use of real-ear simulators and the need for a comprehensive computer-based model of an entire hearing aid.

Acoustic Impedance Tests↗

PubMed1978

Mathematical predictions of electroacoustic frequency response of in situ hearing aids.

The amplitude spectrum of an acoustic signal presented to the microphone of a hearing aid is altered drastically before it finally reaches the user's eardrum. A major part of this alteration is due to the interaction of various mechanical and acoustic resonances which are characteristic of the hearing-aid receiver and the sound transmission system linking the receiver with the eardrum. Because of the complexity of this phenomenon, there is yet no means for predicting, a priori, the true shape of the sound spectrum that will occur at the user's eardrum. This paper reports on the development and testing of just such a scheme. The accuracy of this scheme--a computer-aided mathematical technique--is measured in the laboratory on real and artificial ears. The results of those measurements show good agreement between experimental and computer-generated data below 5000 Hz.

Acoustics↗