Search PubMed⌕ Search

Biomedical subjects

D Beysens

Publications and source records attributed to D Beysens.

At least 19 recordsLinked to original sources

Experimental evidence of the vapor recoil mechanism in the boiling crisis.

Boiling crisis experiments are carried out in the vicinity of the liquid-gas critical point of H2. A magnetic gravity compensation setup is used to enable nucleate boiling at near critical pressure. The measurements of the critical heat flux that defines the threshold for the boiling crisis are carried out as a function of the distance from the critical point. The obtained power law behavior and the boiling crisis dynamics agree with the predictions of the vapor recoil mechanism and disagree with the classical vapor column mechanism.

Journal Article↗

Piston-effect-induced thermal jets in near-critical fluids.

In very compressible fluids, such as fluids near their critical point, the bulk fluid is adiabatically thermalized by the expansion of a hot boundary layer. Thanks to this thermomechanical process (the so-called piston effect) the fluid velocity at the edge of the boundary layer can become very high when the heating power is concentrated in a fissure. Spectacular jets are then observed in SF6 and CO2. Data obtained under weightlessness (in order to remove convection) and data obtained under earth gravity are compared and analyzed. They emphasize the key role of the boundary layer expansion for thermal phenomena in compressible fluids and the hydrodynamic nature of the piston effect.

Journal Article↗

Contact line dynamics in drop coalescence and spreading.

The dynamics of coalescence of two water sessile drops is investigated and compared with the spreading dynamics of a single drop in partially wetting regime. The composite drop formed due to coalescence relaxes exponentially toward equilibrium with a typical relaxation time that decreases with contact angle. The relaxation time can reach a few tenths of seconds and depends also on the drop size, initial conditions, and surface properties (contact angle, roughness). The relaxation dynamics is larger by 5 to 6 orders of magnitude than the bulk hydrodynamics predicts, due to the high dissipation in the contact line vicinity. The coalescence is initiated at a contact of the drops growing in a condensation chamber or by depositing a small drop at the top of neighboring drops with a syringe, a method also used for the studies of the spreading. The dynamics is systematically faster by an order of magnitude when comparing the syringe deposition with condensation. We explain this faster dynamics by the influence of the unavoidable drop oscillations observed with fast camera filming. Right after the syringe deposition, the drop is vigorously excited by deformation modes, favoring the contact line motion. This excitation is also observed in spreading experiments while it is absent during the condensation-induced coalescence.

Journal Article↗

Fast heat transfer calculations in supercritical fluids versus hydrodynamic approach.

This study investigates the heat transfer in a simple pure fluid whose temperature is slightly above its critical temperature. We propose an efficient numerical method to predict the heat transfer in such fluids when the gravity can be neglected. The method, based on a simplified thermodynamic approach, is compared with direct numerical simulations of the Navier-Stokes and energy equations performed for CO2 and SF6. A realistic equation of state is used to describe both fluids. The proposed method agrees with the full hydrodynamic solution and provides a huge gain in computation time. The connection between the purely thermodynamic and hydrodynamic descriptions is also discussed.

Journal Article↗

Microstructure and dynamics near an attractive colloidal glass transition.

The microstructure and dynamics of a colloidal system interacting via short-ranged interparticle potential is studied by ultra-small-angle x-ray scattering and x-ray photon correlation spectroscopy. A colloidal gas-liquid type transition is induced when the short-ranged attractive interactions attain sufficient magnitude. The development of liquidlike structure is preceded by a systematic transition in the particle dynamics from diffusive to constrained motion and then completely frozen behavior. This demonstrates the existence of a jamming transition induced by strong short-ranged attractive interactions even at low packing fractions.

Journal Article↗

Gas spreading on a heated wall wetted by liquid.

This study deals with a simple pure fluid whose temperature is slightly below its critical temperature and whose density is nearly critical, so that the gas and liquid phases coexist. Under equilibrium conditions, such a liquid completely wets the container wall and the gas phase is always separated from the solid by a wetting film. We report a striking change in the shape of the gas-liquid interface influenced by heating under weightlessness where the gas phase spreads over a hot solid surface showing an apparent contact angle larger than 90 degrees. We show that the two-phase fluid is very sensitive to the differential vapor recoil force and give an explanation that uses this nonequilibrium effect. We also show how these experiments help to understand the boiling crisis, an important technological problem in high-power boiling heat exchange.

Journal Article↗

Thermalization of a two-phase fluid in low gravity: heat transferred from cold to Hot

We present an experimental study of the thermal response to a positive temperature quench in two-phase fluid SF6 in low gravity for temperature ranging from 10.1 to 0.1 K from the critical temperature. The temperature was measured simultaneously in the gas, the liquid, and the cell wall by thermistors and the density distribution was observed by interferometry. During the quench the gas temperature considerably exceeded the temperature of the heating walls (overheating up to 23%). This striking observation is discussed in the light of the adiabatic heat transfer in this highly compressible fluid while the key role of the localization in low gravity of the gas and liquid phases is revealed.

Journal Article↗

Magnetic compensation of gravity forces in (p-) hydrogen near its critical point: application to weightless conditions

We report a study concerning the compensation of gravity forces in two-phase (p-) hydrogen. The sample is placed near one end of the vertical z axis of a superconducting coil, where there is a near-uniform magnetic field gradient. A variable effective gravity level g can thus be applied to the two-phase fluid system. The vanishing behavior of the capillary length l(C) at the critical point is compensated by a decrease in g and l(C) is kept much smaller than the cell dimension. For g ranging from 1 to 0.25 times Earth's gravity (modulus g(0)) we compare the actual shape of the meniscus to the expected shape in a homogeneous gravity field. We determine l(C) in a wide range of reduced temperature tau=(T(C)-T)/T(C)=[10(-4)-0.02] from a fit of the meniscus shape. The data are in agreement with previous measurements further from T(C) performed in n-H2 under Earth's gravity. The effective gravity is homogeneous within 10(-2)g(0) for a 3 mm diameter and 2 mm thickness sample and is in good agreement with the computed one, validating the use of the apparatus as a variable gravity facility. In the vicinity of the levitation point (where magnetic forces exactly compensate Earth's gravity), the computed axial component of the acceleration is found to be quadratic in z, whereas its radial component is proportional to the distance to the axis, which explains the gas-liquid patterns observed near the critical point.

Journal Article↗

Frozen wave induced by high frequency horizontal vibrations on a CO2 liquid-gas interface near the critical point.

We used the liquid-vapor equilibrium of CO2 near its critical point (T(C)-T=1 to 150 mK) in order to study the stability of an interface between a gas and a liquid having close densities rho(L) approximately rho(V) when submitted to high frequency f (3-57.5 Hz) horizontal vibrations (of amplitude a from 0.1 to 2.5 mm). Above a given velocity threshold (2piaf )(0) we observed a "frozen wave," corresponding to an interface profile of sinelike shape which is stationary in the reference frame of the vibrated sample cell. By varying the vibration parameters, the surface tension, and the density difference between the two phases via the temperature, it was found that the wavelength and the amplitude of the stationary profile are both increasing functions of the frequency and of the amplitude of the vibration and that they are proportional to the capillary length. Our measurements are consistent with a model of inviscid and incompressible flow averaging the effect of the vibration over a period and leading to a Kelvin-Helmholtz-like instability mechanism due to the relative motion of the two fluids.

Journal Article↗

Viscosity and elasticity during collagen assembly in vitro: relevance to matrix-driven translocation.

In order to better understand the gelation process associated with collagen assembly, and the mechanism of the in vitro morphogenetic phenomenon of "matrix-driven translocation" [S.A. Newman et al. (1985) Science, 228, 885-889], the viscosity and elastic modulus of assembling collagen matrices in the presence and absence of polystyrene latex beads was investigated. Viscosity measurements at very low shear rates (0.016-0.0549 s(-1)) were performed over a range of temperatures (6.9-11.5 degrees C) in a Couette viscometer. A magnetic levitation sphere rheometer was used to measure the shear elastic modulus of the assembling matrices during the late phase of the gelation process. Gelation was detected by the rapid increase in viscosity that occurred after a lag time tL that varied between O and approximately 500 s. After a rise in viscosity that occurred over an additional approximately 500 s, the collagen matrix was characterized by an elastic modulus of the order of several Pa. The lag time of the assembly process was relatively insensitive to differences in shear rate within the variability of the sample preparation, but was inversely proportional to the time the sample spent on ice before being raised to the test temperature, for test temperatures > 9 degrees C. This suggests that structures important for fibrillogenesis are capable of forming at 0 degrees C. The time dependence of the gelation process is well-described by an exponential law with a rate constant K approximately 0.1 s(-1). Significantly, K was consistently larger in collagen preparations that contained cell-sized polystyrene beads. From these results, along with prior information on effective surface tension differences of bead-containing and bead-lacking collagen matrices, we conclude that changes in matrix organization contributing to matrix-driven translocation are initiated during the lag phase of fibrillogenesis when the viscosity is < or = 0.1 Poise. The phenomenon may make use of small differentials in viscosity and/or elasticity, resulting from the interaction of the beads with the assembling matrix. These properties are well described by standard models of concentrated solutions.

Animals↗