Search PubMed⌕ Search

Biomedical subjects

C R Howie

Publications and source records attributed to C R Howie.

At least 19 recordsLinked to original sources

Finite element modelling of the pelvis: inclusion of muscular and ligamentous boundary conditions.

Previous finite element studies of the pelvis, including subject-specific studies have made extensive simplifications with regards to the boundary conditions used during analysis. Fixed boundary conditions are generally utilised at the pubis and superior part of the ilium. While it can be demonstrated that these models provide a close match for certain in vitro experiments that use similar boundary conditions, the resulting stress-strain fields in the cortex in particular are unlikely to be those found in vivo. This study presents a finite element analysis in which the pelvis is supported by muscular and ligamentous boundary conditions, applied using spring elements distributed over realistic attachment sites. The analysis is compared to an analysis in which the pelvis is restrained by fixed boundary conditions applied at the sacro-iliac joints. Striking differences in the stress-strain fields observed in cortical bone in particular, are found between the two analyses. The inclusion of muscular and ligamentous boundary conditions is found to lower the occurrence of stress concentrations within the cortex.

Computer Simulation↗

The elastic properties of morsellised cortico-cancellous bone graft are dependent on its prior loading.

Confined compression experiments were carried out on cortico-cancellous bone taken from bovine femoral condyles to assess the effect of prior loading on the elastic confined modulus, E(c) of morsellised cortico-cancellous bone (MCB). Measurements were taken to find the values of E(c) for MCB subjected to cyclic loading resulting in axial stresses in the range of 0.5-3.0 N mm(2). Two values of E(c) were considered: E(ic), the instantaneous modulus, and E(dc), the delayed modulus allowing for stress relaxation effects. It was found that the values of E(c) increased with increasing maximum axial stress. It was also found that for each stress level the values of E(c) increased as the number of load cycles increased. The dependence of E(c) on the maximum axial stress and the number of load cycles is seen to explain the wide range of values for the apparent modulus of MCB found in previous studies. Tests examining the stress relaxation behaviour of MCB are also discussed. The results indicate that a minimum of 10 compaction episodes are required for MCB to achieve around 90% of its predicted maximum stiffness for a given compaction force.

Animals↗

3D non-linear analysis of the acetabular construct following impaction grafting.

The study investigates the short-term behaviour of the acetabular construct following revision hip arthroplasty, carried out using the Slooff-Ling impaction grafting technique; using 3D finite element analyses. An elasto-plastic material model is used to describe the constitutive behaviour of morsellised cortico-cancellous bone (MCB) graft, since it has been shown that MCB undergoes significant plastic deformation under normal physiological loads. Based on previous experimental studies carried out by the authors and others, MCB is modelled using non-linear elasticity and Drucker Prager Cap (DPC) plasticity. Loading associated with walking, sitting down, and standing up is applied to the acetabular cup through a femoral head using smooth sliding surfaces. The analyses yield distinctive patterns of migration and rotation due to different activities. These are found to be similar to those observed in the clinical setting.

Acetabulum↗

Epidemiology of dislocation after total hip arthroplasty.

Instability after total hip arthroplasty is an important complication. It usually occurs in the immediate postoperative period, but the risk also increases with time. There are numerous surgical treatment options, but they have relatively unpredictable outcomes. Numerous factors are associated with dislocation, but research has mainly focused on surgical factors. Epidemiological factors remain the subject of much debate. We aimed to establish the most significant epidemiological factors in Scotland and in particular the dislocation rate in neuromuscular conditions. The Scottish National arthroplasty nonvoluntary registry is based on SMR01 records (Scottish Morbidity Record) data. We analyzed the Scottish National Arthroplasty Project to find patients' dislocation rates up to 1 year postoperatively for surgeon volume, age, gender, previous surgery, diagnosis, and followup duration. There were 14,314 total hip arthroplasties performed from April 1996 to March 2004 with an annual incidence of dislocation of 1.9%. We found an association between rate of dislocation with age, surgical volume, and previous fracture. However, there was no increase in the rate of dislocation associated with gender or with diagnoses of stroke or Parkinson's disease. Our prognostic assessment of dislocation risk allows assessment for methods of reducing dislocation in high risk patients.

Age Distribution↗

Assessment of a self-administration protocol for extended subcutaneous thromboprophylaxis in lower limb arthroplasty.

The risk of venous thromboembolism in patients following arthroplasty may be reduced by continuing chemical thromboprophylaxis for up to 35 days post-operatively. This prospective cohort study investigated the compliance of 40 consecutive consenting patients undergoing lower limb arthroplasty with self-administration of a recommended subcutaneous chemotherapeutic agent for six weeks after surgery. Compliance was assessed by examination of the patient for signs of injection, number of syringes used, and a self-report diary at the end of the six-week period. A total of 40 patients, 15 men and 25 women, were recruited. One woman was excluded because immediate post-operative complications prevented her participation. Self-administration was considered feasible in 87% of patients (95% confidence interval (CI) 76 to 98) at the time of discharge. Among this group of 34 patients, 29 (85%) were compliant (95% CI 73 to 97). Patients can learn to self-administer subcutaneous injections of thromboprophylaxis, and compliance with extended prophylaxis to six weeks is good.

Anticoagulants↗

The effect of acetabular cup size on the short-term stability of revision hip arthroplasty: a finite element investigation.

The study uses idealized two-dimensional finite element models to examine the behaviour of the acetabular construct following revision hip arthroplasty, carried out using the Slooff-Ling impaction grafting technique. The behaviour of bone graft was considered in detail, with non-linear elasticity and non-associated plasticity being adopted. Load was applied to the acetabular construct through a femoral head using smooth sliding surfaces. In particular, four models were subjected to two idealized cyclic load cases to investigate the effect of acetabular cup size on the short-term stability of the acetabular construct. The study suggests that benefits may be gained by using the largest practical size of acetabular cup.

Acetabulum↗

Impaction grafting with morsellised allograft and tricalcium phosphate-hydroxyapatite: incorporation within ovine metaphyseal bone defects.

An ovine model was used to investigate the in vivo properties of impacted tricalcium phosphate-hydroxyapatite (TCP-HA) aggregates, varying in chemical composition (ratio of TCP to HA) and particle size distribution (8 versus 3 particle size ranges). All pellets were impacted to a standard compactive effort. Eight sheep underwent implantation of pellets in 4 metaphyseal defects in both rear limbs. Treatment groups consisted of: (1) allograft (clinical control). (2) 50/50 allograft/80% HA/20% TCP in 8 particle size ranges, (3) 50/50 allograft/80% TCP/20% HA in 8 sizes and (4) 50/50 allograft/80% HA/20% TCP in only 3 sizes of particles. Healing of defects was evaluated at 14 weeks with computed tomography, histology and histomorphometry. The computer tomography (CT) density measured in all defects containing synthetic agents was higher than in defects filled with allograft alone (p<0.01). Defects containing 8 sizes of 80% HA/ 20% TCP granules (group 2) achieved lower histological scores and contained less bone than the clinical control (p<0.05), whereas groups 3 and 4 did not differ from the control. Although all synthetic agents were osteoconductive, our results suggest that increasing the ratio of TCP over HA and limiting the number of particle size ranges to 3 instead of 8 improve the performance of impacted aggregates as graft expanders. Evaluation under loading conditions of morsellised allograft expanded with 80% TCP/20% HA (BoneSave) in 3 particle size ranges is warranted.

Animals↗

An ovine model to evaluate the biologic properties of impacted morselized bone graft substitutes.

The objectives of this study were to develop and evaluate a bone-defect model to study the biologic behavior of biomaterials being considered for impaction grafting in revision hip arthroplasty. A miniature impactor was designed to produce pellets of aggregates at a standard compactive effort. In Phase 1, 22 sheep underwent implantation of pellets into six metaphyseal defects in both rear limbs. In Phase 2, eight sheep underwent surgical implantation of four pellets in metaphyseal defects. Defects were sealed with polymethylmethacrylate in both phases. Healing of the defects was evaluated at 7 weeks (Phase 1, n = 11) and 14 weeks (n =19) with computed tomography, histology, and histomorphometry. Complications in Phase 1 included four femoral fractures and migration of cement seals (18/102 defects). No complications occurred in Phase 2. Whereas no difference was found between left and right limbs, osteogenesis and incorporation of biomaterials varied among implantation sites. For comparison of grafting materials, treatment site allocations were randomized according to a Latin square design. This model allows evaluation of several impacted aggregates (including large particles) in the same animal. It is particularly suitable for analyzing the biologic properties of grafting materials prior to evaluation under loading conditions.

Animals↗

Early dissolution of a morsellised impacted silicate-free bioactive glass in metaphyseal defects.

The purpose of this study was to evaluate the biological properties of idealized, morsellised impacted Corglaes, a soluble silicate-free glass. Twenty-two sheep underwent implantation of pellets in six metaphyseal defects in both rear limbs. Particle size distribution of all aggregates (except the autograft) approached the ideal logarithmic grading line and all implants were impacted to a standard compactive effort. Treatment groups consisted of (1) empty defect (negative control), (2) autograft (positive control), (3) allograft (clinical control), (4) allograft idealized with Corglaes, (5) 50/50 allograft/Corglaes and (6) Corglaes. Defects were sealed with polymethylmethacrylate. Healing of the defects was evaluated at 7 weeks (n=6) and 14 weeks (n=16) with computed tomography, histology, and histomorphometry. Remnants of Corglaes were found within one of the defects 7 weeks after implantation. Defects filled with mixtures containing 50% or 100% Corglaes were less dense, contained less bone and more fibrous tissue than defects with allograft, autograft, or allograft idealized with Corglaes. Allograft idealized with Corglaes may be considered for impaction grafting in revision hip arthroplasty, as well as local delivery of antibiotics. However, further studies and potential revision of the agent are required before mixtures containing concentrations of Corglaes equal to or higher than 50% can be recommended.

Animals↗

Mechanical considerations in impaction bone grafting.

In impaction grafting of contained bone defects after revision joint arthroplasty the graft behaves as a friable aggregate and its resistance to complex forces depends on grading, normal load and compaction. Bone mills in current use produce a distribution of particle sizes more uniform than is desirable for maximising resistance to shear stresses. We have performed experiments in vitro using morsellised allograft bone from the femoral head which have shown that its mechanical properties improve with increasing normal load and with increasing shear strains (strain hardening). The mechanical strength also increases with increasing compaction energy, and with the addition of bioglass particles to make good the deficiency in small and very small fragments. Donor femoral heads may be milled while frozen without affecting the profile of the particle size. Osteoporotic femoral heads provide a similar grading of sizes, although fewer particles are obtained from each specimen. Our findings have implications for current practice and for the future development of materials and techniques.

Bone Density↗

Medial epicondylitis of the elbow.

Ninety-five cases of medial epicondylitis are reported in 83 patients; 90% were related to work and only 10% to sport or leisure activities. Most recovered with conservative treatment. Operation was needed in 12%, which compared with under 4% of patients with lateral epicondylitis over the same period. The results of open release of the common flexor origin were good, with only one exception.

Adolescent↗

Localised endosteal bone lysis in relation to the femoral components of cemented total hip arthroplasties.

Four cases are described of localised endosteal bone lysis in the femur occurring in association with cemented femoral components that were not obviously 'loose' radiologically. In each, the area of lysis was shown at operation to be related directly to a region in which there was a local defect in the cement mantle surrounding the stem. Via the space between the stem and cement, such defects provide a route through which the contents of the joint cavity may reach the endosteal surface of the femur, subsequently leading to localised bone lysis, and later to frank loosening.

Aged↗

Fixation of displaced subcapital femoral fractures. Compression screw fixation versus double divergent pins.

One hundred and twenty-seven consecutive patients with displaced subcapital fractures of the femoral neck (Garden Grade III or IV) all under 80 years of age and independently mobile, were randomly allocated to fixation with either double divergent pins or a single sliding screw-plate device. The incidence of non-union and infection in the sliding screw-plate group was significantly higher, and we believe that when internal fixation is considered appropriate multiple pinning should be used. Mobility after treatment was disappointing in about half of the patients, and we feel that internal fixation can only be justified in patients who are physiologically well preserved and who maintain a high level of activity.

Adult↗

Intramedullary locking nails in the management of femoral shaft fractures.

Intramedullary locking nails have proved to be of considerable advantage when treating complex, comminuted or segmental femoral shaft fractures. We have reviewed 117 patients with 120 femoral shaft fractures treated with the Strasbourg device. These included 20 compound fractures, 13 pathological fractures and two non-unions. Rehabilitation and union rates have been very satisfactory and there have been no serious infections in the series. Comminution of the proximal femur has occurred in six patients and there have been three femoral neck fractures, but all of these have healed without further complications.

Adolescent↗