Biomedical subjects

Alexander Argyros

Publications and source records attributed to Alexander Argyros.

4 recordsLinked to original sources

PubMed2006

Hollow-core microstructured polymer optical fiber.

We have fabricated microstructured polymer optical fibers that guide light in a hollow core using the photonic bandgap mechanism. The hollow core allows the use of polymer fibers to be extended to wavelength ranges where material absorption typically prohibits their use, with attenuation lower than the material loss observed in the infrared. The fabrication method is similar to other microstructured polymer optical fibers, which has favorable implications for the feasibility of manufacturing such bandgap fibers.

Journal Article↗

PubMed2005

Continuous wave ultraviolet light-induced fiber Bragg gratings in few- and single-mode microstructured polymer optical fibers.

We report observations and measurements of the inscription of fiber Bragg gratings (FBGs) in two different types of microstructured polymer optical fiber: few-mode and an endlessly single mode. Contrary to the FBG inscription in silica microstructured fiber, where high-energy laser pulses are a prerequisite, we have successfully used a low-power cw laser source operating at 325 nm to produce 1 cm long gratings with a reflection peak at 1570 nm. Peak reflectivities of more than 10% have been observed.

Journal Article↗

PubMed2004

Microstructured polymer fiber laser.

A microstructured polymer optical fiber doped with Rhodamine 6G dye was fabricated and demonstrated as an optical amplifier and a fiber laser. As an amplifier, the fiber achieved a gain in excess of 30 dB. As a pulsed fiber laser, the fiber exhibited a threshold of 20 microJ, a slope efficiency of 18%, and a lifetime as high as 130,000 shots at 10 Hz. The maximum output energy was 16 microJ. The advantages that such fibers offer lie in the simplicity and flexibility of their fabrication and in their potential for use as compact, tunable solid-state sources.

Journal Article↗

PubMed2004

Small-core single-mode microstructured polymer optical fiber with large external diameter.

A preform sleeving technique is demonstrated that allows the fabrication of single-mode polymer microstructured fiber with the smallest core and hole dimensions yet reported to our knowledge. For a fixed triangular hole pattern a range of fibers is produced by adjustment to the operating conditions of the draw tower. Numerical modeling is carried out for one of the fibers produced with a 570-microm external diameter, a core diameter of 2.23 microm, an average hole diameter of 0.53 microm, and an average hole spacing of 1.38 microm. This fiber was shown to be endlessly single mode.

Journal Article↗