Search PubMed⌕ Search

Biomedical subjects

A Mital

Publications and source records attributed to A Mital.

At least 37 records · Page 2Linked to original sources
PubMed1995

An ergonomic evaluation of dexterity and tactility with increase in examination/surgical glove thickness.

Latex gloves of five different thicknesses (0.21 mm, 0.51 mm, 0.65 mm, 0.76 mm, and 0.83 mm) were manufactured in-house and tested for dexterity and tactility; dexterity and tactility measures with the bare hand were used as control values. Fifteen adult males (mean age = 22.8 years, mean stature = 179 cm, mean body weight = 75.4 kg, mean palm width = 9.9 cm, mean palm depth = 10.9 cm, and mean middle finger length = 9 cm) and five adult females (mean age = 21.2 years, mean stature = 168 cm, mean body weight = 53.6 kg, mean palm width = 8 cm, mean palm depth = 8 cm, and mean middle finger length = 8.3 cm) voluntarily participated. The gloves also were tested for punctures resulting from impact forces encountered during routine hand movements. The results indicated that the latex glove with 0.83 mm thickness successfully resisted routine impact forces and at the same time provided dexterity and tactility comparable to the bare hand. Thinner gloves failed the impact test and punctured. This indicates that it is possible to greatly reduce the incidence of exposure to contaminated body fluids through accidental needlesticks without compromising the preferred hand's capabilities.

Blood-Borne Pathogens↗
PubMed1994

A quantitative evaluation of gloves used with non-powered hand tools in routine maintenance tasks.

Non-powered hand tools are a major means of carrying out routine maintenance and repair activities. The use of gloves in such situations is essential in order to protect the hands from potential injuries. Together, the gloves and hand tools accomplish the task by transmitting the muscle force on to the workpiece. Several studies have reported that the capability of hands to exert force/torque is severely influenced by the use of gloves. The use of gloves could also lead to a cumulative trauma disorder, rapid onset of muscular fatigue, etc. Most previous studies have focused on determining the influence of gloves on grip strength or push/pull forces one would exert while using devices such as knives. The purpose of this study was to determine the influence of a variety of commercially available gloves on the force/torque exertion capability of workers with wrenches and screwdrivers that are commonly used in performing routine maintenance and repairs. Nineteen males participated in the study and, using seven different hand tools and nine varieties of commercial gloves, exerted peak volitional torques on a simulated workpiece. The peak torque and electromyogram of flexor and extensor muscles were recorded. The results indicated that muscle activity did not differ significantly between the glove and no-glove conditions and the peak torque exertion capability of individuals generally increased with gloves. The magnitude of torque exerted on the workpiece was different for different gloves. The results also contradict some of the previously reported findings.

Adult↗
PubMed1994

Determination of gross weight limit for foldaway powered wheelchairs through isometric and psychophysical strength simulations.

This study concerns the maximum weight of a powered wheelchair for transfer to and from the trunk of a car by individuals with limited exercise endurance. The loading and unloading of a folded wheelchair from the trunk of a medium size American car was simulated. Both static and dynamic simulations were carried out. The isometric (static) and psychophysical (dynamic) strengths of eight adult males while simulating the loading/unloading activities were measured. The results indicated that: (1) the maximum weight of a powered foldaway wheelchair that individuals can load in the car and unload from the car is much lower than the weight of most commercially available powered wheelchairs, and (2) static simulation of the folded wheelchair loading and unloading activity provides wheelchair weight ceiling that is easily exceeded during the dynamic simulation of the activity. The upper limit on the weight of a foldaway powered wheelchair is provided and implications of this limit on future foldaway powered wheelchair designs are briefly discussed. In addition, the user gender and age effects on the foldaway powered wheelchair weight ceiling are also discussed.

Adult↗
PubMed1994

The injury profile of a large telecommunication company: a statistical summary.

Overexertion injuries have been a major concern to occupational safety and health professionals for quite some time. Over the years, these injuries have continued to increase despite ergonomic interventions to control their frequency of occurrence. It has been speculated that this increase may be due primarily to enhanced awareness and better record-keeping. Many occupational safety and health professionals also presume that overexertion injuries and occupational illnesses are confined to heavy manufacturing industries. This paper reports occupational injury and illness data from a large telecommunication industry, collected over a 7-year period. Three observations were made from the statistical summary: (1) better record keeping may be a reason behind the reported increase in injuries; workday losses decline as a result of improved ergonomic and occupational health interventions; (2) serious injuries are not just limited to heavy manufacturing industries; and (3) reduction in workday losses may not translate in injury cost savings.

Adult↗
PubMed1994

The effect of different work-rest schedules on fatigue and performance of a simulated directory assistance operator's task.

The directory assistance operators' task with a visual display terminal was simulated to determine the preferable work-rest schedule from among the three different work-rest schedules: 30 min of work followed by 5 min break (30-5); 60 min of work followed by 10 min break (60-10); and 120 min of work without any break (120-0). The total working duration was 2 h. The errors made during the work and the subjective responses before and after the working period (2 h) were recorded and analysed. The results showed that the first two work-rest schedules were preferable to the third condition (120-0) as significantly fewer errors were made (p > or = 0.01) when a short break was provided. There was no significant difference (p > or = 0.10) in errors between (30-5) and (60-10) schemes. Fewer before and after subjective responses differed significantly for (30-5) and (60-10) schemes than for the (120-0) scheme. The overall effect of schemes on subjective responses, however, was not statistically significant at the 5% level. Since both (30-5) and (60-10) schemes were found acceptable, the (60-10) scheme is recommended since it is easy to implement, causes fewer breaks and therefore, fewer work interruptions, and leads to fewer total minutes of break.

Adolescent↗
PubMed1994

Physical fatigue in high and very high frequency manual materials handling: perceived exertion and physiological indicators.

This paper presents the results of a preliminary laboratory study undertaken to determine the perceived exertion and physiological responses of highly trained and experienced workers to high (up to 16 repetitions/min) and very high frequency (above 16 repetitions/min) manual lifting, lowering, and carrying/turning tasks. The results indicate that workers engaged in such highly repetitive and physically demanding tasks may operate at psychophysical workloads that may clearly be considered physically fatiguing and unacceptable according to the current physiological design criteria. In this study subjects performing lifting and lowering tasks, on the average, operated at 57% and 52% of their uphill treadmill aerobic capacity, respectively. For carrying and turning tasks, the average metabolic energy expenditure rate corresponded to 43% of subjects' aerobic capacity. The overall heart rates of the study subjects were 155 beats per minute (bpm) for lifting, 144 bpm for lowering, and 142 bpm for carrying and turning. These physiological responses, when compared with recommended physiological design criteria, are excessively high. The ratings of perceived exertion (RPE) for the shoulder, back, and whole body were highest for lifting (range, 10.20-15.50) and least for carrying and turning (range, 10.30-13.40; carrying and turning activities also included RPE of arms). Generally workers perceived the associated physical exertions as acceptable.

Adult↗
PubMed1992

Noise in multiple-workstation open-plan computer rooms: measurements and annoyance.

Computers in the workplace have become very prevalent. As with the introduction of any new technology, unanticipated problems often develop. Noise in open-plan computer rooms and annoyance and perceived deterioration in performance associated with it also appears to be a problem that may be similarly categorized. An experimental investigation was undertaken as a result of frequent user complaints about the difficulty of concentrating and performing their work in the computer rooms of a large service organization. Two typical computer rooms were investigated. Noise levels were measured at random times during the working hours. The noise spectrum was found to be almost similar in both facilities. The 10-second A-weighted noise level for all frequencies ranged between 53 and 62 dB. Most noise energy was either in the high-frequency bands (above 2,000 Hz) or low-frequency bands (below 500 Hz). The highest noise energy levels were recorded at 8,000 Hz (between 64 and 73 dB). Least noise energy levels were recorded between 500 and 2,000 Hz (between 35 and 44 dB). The noise spectrum, thus, was substantially different from those of open-plan offices. Eighty-nine percent of the users questioned indicated their tasks required concentration. Fifty percent of all respondents rated the noise level between extremely annoying and unbearable and intolerable (scale values between 22 and 25 on a 25-point scale; 1 being noticeable but not objectionable and 25 being unbearable and intolerable); 10% of the respondents considered the noise very annoying; 20% of the respondents considered the noise levels moderately annoying; the remaining respondents did not seem to have a major problem. Conversational sound and computer-printer beeping sounds were reported to be most annoying by 90% of the respondents who considered the noise levels annoying. Constant arrival and departure of users, sound from keyboards, and ventilation equipment also appeared to be major contributing factors.

Computer Terminals↗
PubMed1991

A lighting evaluation of a facility for the elderly.

A residential facility for the aged was evaluated for their illumination needs. Only the shared facility and grounds immediately surrounding it were considered. The facility evaluated is one of the most modern and the lighting design is considered its best feature. The age of residents occupying the facility ranges from 60 to 85 years. The lighting evaluation included administering a lighting adequacy/inadequacy questionnaire and measurement of actual light levels in the various parts of the facility during the day and after dark hours. The results indicated that lighting in approximately half the areas surveyed was substandard. An attempt to develop recommendations for the lighting needs of the elderly was unsuccessful. It was concluded that realistic illumination level recommendations need to be developed for the elderly.

Aged↗
PubMed1990

Psychophysical models for manual lifting tasks.

This paper provides two models for males and females to assess the psychophysical maximum acceptable weight of lift. The weight guidelines generated by the models are a function of lifting frequency, height of lift, sagittal or asymmetrical lifting, task duration, container size in the sagittal plane, presence or absence of container couplings, and percentage of the working population. The developed models were generated from a knowledge base available in the published literature. A computer program was written in BASIC to assist the user in determining the safe load that could be handled by a specified working population. Model validation showed that the models developed predict the maximum acceptable weight of lift with a reasonable degree of accuracy. A comparison between the National Institute for Occupational Safety and Health recommendations and those made on the basis of the models developed in this paper is also presented.

Journal Article↗
PubMed1989

Portability of three consumer products.

Three consumer products (a television set, a personal computer and a typewriter), all considered portable by their respective manufacturers, were evaluated experimentally for portability. Products were not considered portable if the physical and subjective workloads resulting from carrying them over specified distances were excessive. Twenty-two males and six females participated in the experimental investigation and carried the three products for distances of 45.72, 91.44. 137.16 and 182.88 m. Their pulse and ratings of perceived exertion (RPE) of the arms and whole body were recorded and used as measures of physical and perceived workloads. Both physiological and subjective responses to carrying products were significantly influenced by the type of product and carrying distance, regardless of the gender of the person performing the carrying. The results of this study and the design guidelines provided in the literature for one-handed and two-handed carrying tasks led to the conclusion that, of the three products, only the television set could be considered portable.

Journal Article↗
PubMed1989

Effects on load handling of restricted and unrestricted shelf opening clearances.

Changes in psychophysical lifting capacity with reductions in shelf opening clearances were experimentally determined. Three levels of shelf opening clearances were studied: unrestricted shelf opening clearance, loose shelf opening clearance (a clearance of 15 mm between the box width and the shelf opening), and tight shelf opening clearance (a clearance of 3 mm between the box width and the shelf opening). Two levels of lifting frequency (1 and 4 lifts/min.) and two lifting heights (floor to 0.81 m and 0.81 m to 1.52 m) were included. The metabolic energy expenditure rates and heart rates of the subjects (8 males and 8 females) at psychophysically acceptable weights of lift were also recorded to assess the physiological burden. The results indicated a decline in the psychophysical lifting capacity of the subjects as the shelf opening clearance became narrower. The decline in psychophysical capacity, compared to unrestricted shelf opening clearance for males was 9% when the shelf opening clearance was 15 mm. A further decline of almost 4% was recorded when the shelf opening clearance narrowed down to 3 mm. For females, the corresponding declines were approximately 10% and 4%. The effects of lifting frequency and height of lift were found to be consistent with previous findings.

Adolescent↗
PubMed1989

An endurance training programme for frequent manual carrying tasks.

This study was conducted with the aim of testing whether the endurance time of new employees engaged in frequent industrial carrying tasks can be significantly increased through a short training programme (2.5 weeks). Endurance time was here defined as the maximum length of time during which an individual can continuously carry a 20 kg load over a 4 m distance 8 times/min. The results showed that (1) endurance time increased by almost 100% over an 8-session training programme; (2) for a fixed workload, endurance time increased without changing job demand perception; and (3) overall body fatigue may be the limiting factor in frequent carrying tasks.

Adult↗
PubMed1989

The moderating effects of production feedback and standards on the relationship between worker job attitudes and productivity.

An experimental study was performed to investigate the impact of production feedback and standards, singly as well as jointly, as moderators of the worker job attitudes-productivity relationship in a repetitive production task. There was no substantial or consistent correlation between worker job attitudes and productivity and the correlation coefficient values in general were not statistically significant. The provision of production feedback and standards affected worker job attitudes and productivity differently and this in turn had an effect on the job attitudes-productivity relationship.

Adolescent↗
PubMed1988

Physiological guidelines for the design of manual lifting and lowering tasks: the state of the art.

The goal of many researchers and practitioners of occupational health and safety has been to design manual materials handling (MMH) tasks so as to reduce the frequency and severity of overexertion injuries usually associated with these types of tasks. Physiological limits with respect to the manual lifting and lowering aspects of MMH have been reviewed and evaluated. The information provided by different researchers has been presented in a concise manner that is easily accessed by designers and practitioners of MMH. Recommendations for future research in determining physiological limits of individuals engaged in manual lifting and lowering tasks and other aspects of MMH activities have been provided.

Energy Metabolism↗
PubMed1987

Injuries due to handtools. Results of a questionnaire.

A questionnaire was mailed to various federal and state agencies in the United States to determine the frequency, severity and annual cost of handtool-related injuries in industry and to identify problem areas with regard to tool type, accident type, nature of injury, parts of body affected, type of industry and characteristics of the injured worker. The responses of various state and regional agencies were tabulated and analysed. This paper summarises the findings.

Journal Article↗