Search PubMed⌕ Search

Biomedical subjects

A Baratoff

Publications and source records attributed to A Baratoff.

At least 19 recordsLinked to original sources
PubMed2005

Energy level alignment at metal-octaethylporphyrin interfaces.

We studied the electronic structure of copper-octaethylporphyrin (CuEOP) adsorbed on three metal surfaces--Ag(001), Ag(111), and Cu(111)--by means of ultraviolet photoelectron spectroscopy (UPS). The adsorption-induced work function shifts saturate roughly beyond two monolayers. The saturation values are substrate dependent, negative, and range from -1.30 to -0.85 eV. This shift is larger than that for tetraphenylporphyrins. The two highest occupied molecular orbitals (HOMO and HOMO-1) of the organic are clearly resolved in the UPS spectra. The origin of the negative work function shift is discussed.

Journal Article↗
PubMed2004

Sublattice identification in scanning force microscopy on alkali halide surfaces.

We propose and apply to the KBr(001) surface a new procedure for species recognition in scanning force microscopy (SFM) of ionic crystal surfaces which show a high symmetry of the charge arrangement. The method is based on a comparison between atomistic simulations and site-specific frequency versus distance measurements. First, by taking the difference of force-distance curves extracted at a few judiciously chosen surface sites we eliminate site-independent long-range forces. The obtained short-range force differences are then compared with calculated ones assuming plausible tip apex models. This procedure allows for the first time identification of the tip apex polarity and of the positive and negative sublattices in SFM images of the (001) cleavage surface of an ionic crystal with the rock salt structure.

Journal Article↗
PubMed2003

Molecular assembly and self-assembly: molecular nanoscience for future technologies.

In this review the emerging science of single molecules is discussed in the perspective of nanoscale molecular functions and devices. New methods for the controlled assembly of well-defined molecular nanostructures are presented: self assembly and single molecular positioning. The observation and selective modification of conformation, electronics, and molecular mechanics of individual molecules and molecular assemblies by scanning probes is demonstrated. To complement this scientific review, some of the possible consequences and visions for future developments are discussed, as far as they derive from the presented systems. The prospects of nanoscale science to stimulate technological evolution are exemplified.

Adsorption↗
PubMed2001

Quantitative measurement of short-range chemical bonding forces.

We report direct force measurements of the formation of a chemical bond. The experiments were performed using a low-temperature atomic force microscope, a silicon tip, and a silicon (111) 7x7 surface. The measured site-dependent attractive short-range force, which attains a maximum value of 2.1 nanonewtons, is in good agreement with first-principles calculations of an incipient covalent bond in an analogous model system. The resolution was sufficient to distinguish differences in the interaction potential between inequivalent adatoms, demonstrating the ability of atomic force microscopy to provide quantitative, atomic-scale information on surface chemical reactivity.

Journal Article↗
PubMed2000

Low temperature scanning force microscopy of the Si(111)-(7x7) surface

A low temperature scanning force microscope (SFM) operating in a dynamic mode in ultrahigh vacuum was used to study the Si(111)- (7x7) surface at 7.2 K. Not only the twelve adatoms but also the six rest atoms of the unit cell are clearly resolved for the first time with SFM. In addition, the first measurements of the short range chemical bonding forces above specific atomic sites are presented. The data are in good agreement with first principles computations and indicate that the nearest atoms in the tip and sample relax significantly when the tip is within a few A of the surface.

Journal Article↗