Search PubMed⌕ Search

Biomedical subjects

A Afshari

Publications and source records attributed to A Afshari.

9 recordsLinked to original sources
PubMed2005

Characterization of indoor sources of fine and ultrafine particles: a study conducted in a full-scale chamber.

UNLABELLED: Humans and their activities are known to generate considerable amounts of particulate matter indoors. Some of the activities are cooking, smoking and cleaning. In this study 13 different particle sources were for the first time examined in a 32 m3 full-scale chamber with an air change rate of 1.7 +/- 0.1/h. Two different instruments, a condensation particle counter (CPC) and an optical particle counter (OPC) were used to quantitatively determine ultrafine and fine particle emissions, respectively. The CPC measures particles from 0.02 microm to larger than 1.0 microm. The OPC was adjusted to measure particle concentrations in eight fractions between 0.3 and 1.0 microm. The sources were cigarette side-stream smoke, pure wax candles, scented candles, a vacuum cleaner, an air-freshener spray, a flat iron (with and without steam) on a cotton sheet, electric radiators, an electric stove, a gas stove, and frying meat. The cigarette burning, frying meat, air freshener spray and gas stove showed a particle size distribution that changed over time towards larger particles. In most of the experiments the maximum concentration was reached within a few minutes. Typically, the increase of the particle concentration immediately after activation of the source was more rapid than the decay of the concentration observed after deactivation of the source. The highest observed concentration of ultrafine particles was approximately 241,000 particles/cm3 and originated from the combustion of pure wax candles. The weakest generation of ultrafine particles (1.17 x 10(7) particles per second) was observed when ironing without steam on a cotton sheet, which resulted in a concentration of 550 particles/cm3 in the chamber air. The highest generation rate (1.47 x 10(10) particles per second) was observed in the radiator test. PRACTICAL IMPLICATIONS: Humans and their activities are known to generate substantial amounts of particulate matter indoors and potentially they can have a strong influence on short-term exposure. In this study a quantitative determination of the emissions of fine and ultrafine particles from different indoor sources was performed. The aim is a better understanding of the origin and fate of indoor particles. The results may be useful for Indoor Air Quality models.

Activities of Daily Living↗
PubMed2004

Emission of phthalates from PVC and other materials.

The main objective of this study was to generate quantitative and qualitative emission data on phthalates from different materials. To achieve this the existing (Chamber for Laboratory Investigations of Materials, Pollution and Air Quality) Climpaq-based procedure for simplified measurements of emissions of plasticizer from PVC and other plasticized materials was modified. It was applied to a range of products. Some of them were suspected of contributing to the indoor concentration of plasticizers. The emissions from PVC flooring, polyolefine flooring, a refrigerator list, two electric cables, PVC skirting and floor wax were studied in separate Climpaqs. The emission from the PVC flooring in the Climpaq was compared with results from the ultra-small chamber Field and Laboratory Emission Cell (FLEC). Sampling and analysis methods were optimized to measure plasticizers. Samples were taken in exhaust air from the chambers after 6, 35, 62, 105, and 150 days from the start of the experiment. PVC flooring was tested for an additional 100 days. Polyolefine covered with wax resulted in an air concentration of 22 microg/m3 of dibutylphthalate (DBP), which is two orders of magnitude larger than any other materials, but did not emit di(2-ethylhexyl)phthalate (DEHP). The other materials resulted in max concentration of approximately 1 microg/m3 of DEHP and low emissions of DBP. The concentration of DEHP in each chamber increased slowly to a rather stable level which was reached after 150 days. DBP concentrations in the chambers with PVC skirting, PVC flooring, polyolefine and floor wax reached their quasi-static equilibrium after 60 days. The modified method did not create sufficient data for the calculation of emission rates. Adsorption of emission on chamber surfaces made it impossible to use the first part of the experiment for emission rate calculation. When the concentration had stabilized, it was found to be almost identical and independent of chamber and ventilation rate. Emission rates were reduced at high concentrations probably because the concentration in the material was near equilibrium with the concentration in the chamber air.

Air Pollution, Indoor↗
PubMed2003

Comparison of three small chamber test methods for the measurement of VOC emission rates from paint.

The aim of this study was to demonstrate a correlation between the measurement of emission rates of volatile organic compounds (VOCs) in three different climate chambers. In order to achieve this aim, the early state of the emission process in the three chambers was investigated and the effects of some important factors on the emission rates from paint were determined. The paper presents results of measurements in three different climate chambers. For the study, a 1-m3 chamber, a field and laboratory emission cell (FLEC), and a chamber for laboratory investigation of materials pollution and air quality (CLIMPAQ) were used. The airflow and surface area were selected so that the area-specific ventilation rates were identical in the three chambers. Temperature and relative humidity were identical during all the measurements. The paint examined was a solvent-based alkyd paint intended for indoor, which use contained between 30 and 60% of white spirit in wet condition. The paint was applied to electropolished and cleaned stainless steel plates. After application, the test material was stored for 14 days for drying in a well-ventilated conditioning room before the measurements were made. After 2 weeks storage, the most pronounced emissions were pentanal, hexanal, octanal, and decanol. The period before the emission rate stabilized differed for the three chambers studied. However, all chambers gave similar emission rates within the overall uncertainty used in these experiments.

Air Pollutants↗
PubMed2001

Characterization of asphalt fume composition under simulated road paving conditions by GC/MS and microflow LC/quadrupole time-of-flight MS.

A highly sensitive, selective, and reliable analytical method has been developed and validated for characterization of asphalt fume generated under simulated road paving conditions. A dynamic asphalt fume generation system was modified to provide consistent test atmospheres at simulated asphalt road paving conditions. In the process of fume generation, asphalt was initially preheated in an oven to 170 degrees C, pumped to a large kettle, which maintained the asphalt temperature between 150 and 170 degrees C, and then transferred to the generator. The fume was conducted from the generator to an exposure chamber through a heated transfer line. Characterization of the asphalt fume test atmospheres included the following: (1) determination of the consistency of the asphalt aerosol composition within the generation system; (2) quantification of total organic matter of the asphalt fume by electron impact ionization of isotope dilution gas chromatography/ mass spectrometry); and (3) identification of individual priority polycyclic aromatic hydrocarbons (PAHs) in asphalt fume by selected ion monitoring. With the developed method, asphalt fumes could be characterized into three fractions: (1) filter collection of a large molecular size fraction over a range of mass-to-charge (m/z) ratios of 173-309; (2) XAD-2 trapping of a medium molecular size fraction over a range of m/z ratios of 121-197; and (3) charcoal trapping of a small molecular size fraction that contained mainly the volatile vapor fraction over a range of m/z ratios of 57-141. Total organic matter of the asphalt fume was quantified over the 5 exposure days. Sixteen specific priority PAHs were monitored and identified. These PAHs were determined at trace levels on the filter fraction. A novel approach, which utilizes collision-induced dissociation of fragmentation pathway leading to a characteristic fragmentation pattern by coupling microflow liquid chromatography to atmospheric pressure chemical ionization of quadrupole time-of-flight mass spectrometry, was used to further clarify the trace amount of key components present in simulated road paving asphalt fumes. These results demonstrate that asphalt fume composition could be characterized and specific priority PAHs could be identified by this method. The major advantages of this method are its highly sensitivity, selectivity, and reliability for chemical hazard characterization in a complex mixture. This method is suitable for support toxicity studies using simulated occupational exposure to asphalt fumes.

Carcinogens, Environmental↗
PubMed2001

Flow cytometric platform for high-throughput single nucleotide polymorphism analysis.

We have developed a rapid, cost-effective, high-throughput readout for single nucleotide polymorphism (SNP) genotyping using flow cytometric analysis performed on a Luminex 100 flow cytometer. This robust technique employs a PCR-derived target DNA containing the SNP, a synthetic SNP-complementary ZipCode-bearing capture probe, a fluorescent reporter molecule, and a thermophilic DNA polymerase. An array of fluorescent microspheres, covalently coupled with complementary ZipCode sequences (cZipCodes), was hybridized to the reaction products and sequestered them for flow cytometric analysis. The single base chain extension (SBCE) reaction was used to assay 20 multiplexed SNPs for 633 patients in 96-well format. Comparison of the microsphere-based SBCE assay results to gel-based oligonucleotide ligation assay (OLA) results showed 99.3% agreement in genotype assignments. Substitution of direct-labeled R6G dideoxynucleotide with indirect-labeled phycoerythrin dideoxynucleotide enhanced signal five- to tenfold while maintaining low noise levels. A new assay based on allele-specific primer extension (ASPE) was validated on a set of 15 multiplexed SNPs for 96 patients. ASPE offers both the advantage of streamlining the SNP analysis protocol and the ability to perform multiplex SNP analysis on any mixture of allelic variants.

Flow Cytometry↗
PubMed2000

Evaluation of percutaneous penetration of natural rubber latex proteins.

Latex allergy is recognized worldwide as a serious health risk. To date, exposure assessment and intervention strategies have focused primarily on respiratory protection; this work evaluates the potential role of dermal protein penetration in the development of latex allergy. In vitro penetration models using flow-through diffusion cells and both human surgical specimens and hairless guinea pig skin (CrL: IAF/HA) demonstrated iodinated latex proteins (ammoniated and non-ammoniated) penetrating into and through both intact and abraded skin. Although less than 1% penetration was observed with intact skin, up to 23% of latex proteins applied to abraded skin were recovered from receptor fluid within 24 h of exposure. Phosphoimaging of the concentrated effluent revealed proteins ranging in size from 3 to 26 kDa. Using a (3)H(2)O penetration assay to evaluate barrier integrity, the amount of latex protein penetration was found to positively correlate with the degree of dermabrasion. Immunohistochemistry of the skin localized latex proteins in the Langerhans cell-rich epidermis and in the dermis. Both in vitro penetration studies and immunohistochemistry supported the use of hairless guinea pig skin as a surrogate for human skin in evaluating latex protein penetration. In studies performed in vivo, 35% of hairless guinea pigs topically exposed to latex proteins (100 microg) 5 days per week for 3 months demonstrated elevations in latex-specific IgG1. The implication for these data is that the skin is not only a plausible route for latex sensitization but can be a major exposure route when the integument has been compromised.

Animals↗
PubMed1993

Organic dust exposure from compost handling: response of an animal model.

The objective of this investigation was to elucidate the pulmonary responses of an animal model to dust generated from leaf/wood compost which had caused a severe case of acute respiratory illness in an individual. Guinea pigs were exposed for 4 hr to 30 mg/m3 of aerosolized leaf/wood compost dust. Inhalation resulted in significant cellular activation and changes in pulmonary mechanics. Maximal elevation in breathing rate (increases 36%) was observed 12-18 hr postexposure. Similarly, maximal granulocyte infiltration (increases 1,600%) and activation of alveolar macrophages (increases 65%) occurred 18 hr postexposure. In contrast, maximal airway obstruction (increases 120%) occurred immediately after exposure and returned toward normal (increases 53%) by 18 hr postexposure. In several respects, the airway obstruction and pulmonary inflammation described in the animal model were comparable to the human response to compost dust. Therefore, this animal model may be useful in predicting the potential respiratory hazard associated with exposure to various organic dusts.

Agriculture↗
PubMed1989

Restricted immunoglobulin variable region gene usage by normal Ly-1 (CD5+) B cells that recognize phosphatidyl choline.

5-15% of lymphocytes in the peritoneums of normal adult B10.H-2aH-4bp/Wts (2a4b) mice are CD5+ (Ly-1) B cells that recognize phosphatidyl choline (PtC), a phospholipid component of all mammalian cells. We produced a set of IgM-secreting hybridomas from the peritoneal cells of normal, adult 2a4b mice. We found that this set of hybridomas shows a similarly high frequency of antibodies specific for PtC (21 of 86) that also react with bromelain-treated mouse erythrocytes. Restriction fragment analysis of Ig gene rearrangements and analysis of expressed Ig idiotypes reveal that these cells use a restricted set of variable region genes to generate the PtC-specific antibodies. The Ig genes used by the PtC-specific hybridomas appear to be the same as those found in the PtC-specific Ly-1 B cell lymphomas, CH27 and CH34.

Animals↗